Микроскоп OLYMPUS IX2 RFAEVA2. Инструкция на английском языке

Modules described
in this manual
IX2-RFAEVA-2
FV5-LAAR
IX2-COMB
FV5-FUR
INSTRUCTIONS
TOTAL INTERNAL
REFLECTION
ILLUMINATION SYSTEM
This instruction manual is for the Olympus Total Internal Reflection Illumination System. To ensure the
safety, obtain optimum performance and to familiarize yourself fully with the use of this system, we
recommend that you study this manual thoroughly before operating the system.
This system employs a laser light source. Take special care for safety and please also read the
instruction manual for the laser light source.
Retain this instruction manual in an easily accessible place near the work desk for future reference.
AX7 385

This device complies with the requirements of directive 98/79/EC concerning in vitro diagnostic
medical devices. CE marking means the conformity to the directive.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

IX2-RFAEVA-2
CONTENTS
CAUTION      This system employs a laser light source and should be assembled and adjusted by qualified
service personnel from Olympus.
Never attempt to assemble or adjust the system for it is extremely hazardous.
IMPORTANT – Be sure to read this section for safe use of the equipment. –          1-7
1     MODULE NOMENCLATURE                                                            8
2     CONTROLS                                                                   9, 10
3     TOTAL INTERNAL REFLECTION FLUORESCENCE OBSERVATION                         11-14
3-1  Conditions of Observation...................................................................................................................................................... 11
3-2  Preparation for Observation ................................................................................................................................................  12
1   Preparing for Laser Beam Introduction        2   Introducing the Laser Beam
3-3  Observation Procedure ..............................................................................................................................................................  13
1   Adjusting the Focus         2   Adjusting the Laser Beam Incidence Angle
4     REFLECTED LIGHT FLUORESCENCE OBSERVATION                                      15
5     USING THE CONTROLS                                                        15, 16
1   Using the Binocular Tube Shutter         2   Using the Specimen Cover
3   Field Iris Aperture Diaphram                 4   Filter Slider
6     TROUBLESHOOTING GUIDE                                                         17
7     SPECIFICATIONS                                                                18
PROPER SELECTION OF THE POWER SUPPLY CORD.............................................................  19, 20