Генератор дыма, снега, мыльных пузырей, конфетти INVOLIGHT BM300. Инструкция на английском языке

BM300
POWER BUBBLE MACHINE
USER MANUAL
Please read over this manual before operation the machine

Introduction                                                                      Setup
Thank you for choosing this Bubble Machine. You now own a rugged and            1. Remove all packing materials from the bubble machine.
powerful state-of-the-art machine. Prior to use, we suggest that you carefully read   not attempt to use it until after contacting your dealer for assistance.
all of the instructions. By following the suggestions found in this user manual, you   2. Place bubble machine on a flat surface.
can look forward to exceptional performance from your Bubble Machine for years     3. Loosen the side screws and lift the housing upwards. You will see a liquid tank.
to come.                                                                           4. Pour bubble liquid into the liquid tank, being careful not to exceed the
Please follow these  operation,  safety and  maintenance  instructions to  ensure     maximum fluid level. Do not overfill.
along and safe life for your Bubble Machine.                                       5. When the container is full, lower the housing and tighten the screws.
Specifications:                                                                    IMPORTAN SAFETY NOTICE:
Model No.: BM300                                                          ?Ensure your bubble machine is unplugged from the mains electrical supply
Remote Control                                                            before attempting to open the housing.
Tank Capacity: 2.5L                                                       ?To help avoid accidental exposure to dangerous live AC mains voltage, two
Approx.Bubble Projection:5meters                                          safety screws are fitted that require a screwdriver to remove. Once these are
Weight:: 14kg                                                             removed, the finger screws can be undone by hand.
Voltage: 220-250V 50/60Hz                                                 ?Once the screws are removed, the lid of the housing can be carefully swung
Power: 300W                                                               upwards, as shown above. Take care not to spill any of the bubble fluid inside
Size: 45*39*41cm                                                          the unit.
?The fluid tank is designed to fit only one way around. Make sure you insert it
Unpacking & Inspection                                                              correctly, as shown above, with the lower edge facing into the machine.
?Open the shipping carton and check that all equipment necessary to operate         ?  Never aim the output at open flames.
the system has arrived intact. In addition to the Bubble Machine, you               ?Position output of bubbles away from persons
should receive the following items:
1. This user manual.                                                               OPERATION
2. A set of remote control.                                                           Turn on the power switch located on the back of the bubble machine. You will
?Before beginning initial setup of your Bubble Machine, make sure that there is no   notice that the internal bubble drum and fan are activated. Bubbles are now
evident damage caused by transportation.                                             produced.
? In the event that the unit’s housing or cable is damaged, do not plug it in and do