Универсальный аудиоинтерфейс для Mac, PC и iPad ROLAND UA-11-MK2. Инструкция на английском языке

Read Me First
About the DUO-CAPTURE mk2’s [COMPUTER/TAB] Switch
The [COMPUTER/TAB] switch located on the bottom panel needs to be placed at the setting that’s
appropriate for the device to which you’re connecting the DUO-CAPTURE mk2.
Switch position  Connected device
For connecting an iPad. Refer to “Using the DUO-CAPTURE mk2 with an iPad” (p. 2).
TAB
Driver installation is not necessary.
For connecting a computer. Refer to “Using the DUO-CAPTURE mk2 with a Computer” (p. 1).
COMPUTER
You must install the driver in your computer.
Bottom panel
Using the DUO-CAPTURE mk2 with a Computer
Rear panel
2
1         Bottom panel
1.	 Set the DUO-CAPTURE mk2’s [COMPUTER/TAB] switch to the “COMPUTER” position.
2.	 Connect the DUO-CAPTURE mk2 to the computer.
MEMO
If you want to connect the DUO-CAPTURE mk2 to a computer in which the USB driver has not been installed, disconnect the DUO-CAPTURE mk2’s
USB cable from the computer, and install the USB driver in the computer as described in the section “Driver Installation” in the DUO-CAPTURE
owner’s manual.
DUO-CAPTURE mk2                                    1              *  5  1  0  0  0  3  1  5  3  0  -  0  1  *

Read Me First
Using the DUO-CAPTURE mk2 with an iPad
Before you continue, please make sure to access the following URL and check the operating requirements and other relevant information.
http://www.roland.com/support/
NOTE
•  The first-generation iPad cannot be used.
•  The iPad app you’re using must support CoreAUDIO.
You’ll need to provide the following items
•  iPad (made by the Apple Inc.)
•  Apple iPad Camera Connection Kit (Camera Connector; made by the Apple Inc.)
•  USB hub (commercially available; a type to which an AC adaptor or other power supply is connected)
•  USB cable (commercially available)
1                                             2
AC adaptor included     USB hub that works with a   Apple iPad Camera
with the USB hub        connected power supply   Connection Kit
(commercially available)  (Camera Connector)
Rear panel
4
3         Bottom panel
1.	 Power up your USB hub (connect the AC adaptor to the USB hub).
2.	 Connect the USB hub to the iPad using the Camera Connector of the Apple iPad Camera Connection Kit.
3.	 Set the DUO-CAPTURE mk2’s [COMPUTER/TAB] switch to the “TAB” position.
4.	 Connect the DUO-CAPTURE mk2 to the USB hub.
MEMO
Operation may be unstable if you use a USB hub of a type that does not have a connected power supply, or if you connect the DUO-CAPTURE mk2
directly to the iPad.
Copyright © 2012 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Company names and product names appearing in this document are registered trademarks or trademarks of their respective owners.
2