Сабвуфер SOUNDMAX SM-CSP12. Инструкция на русском языке

SM-CSP12
12? FREE AIR SUBWOOFER
12? (300 ??) ?KkO??o? O?? ???????o? j???????OK?j?
Instruction manual
??????????? ?? ????????????

Description
Electro-plated IMPP cone
Free air installation is possible
Butyl-rubber edge
Moulded aluminum basket
Antiresonance covering
The set of subwoofer includes:
-  subwoofer
Important safeguards
·  The owner¶s manual contains important operating and maintenance instructions for your safety. It is
necessary to refer the manual.
·  Do not install the subwoofer where it may be subjected to excessive heat moisture, dust or where it will be
kicked repeatedly, brushed or bumped.
·  Make absolutely sure that the terminals for the subwoofer are connected to the proper outputs from the
music source.
·  Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or
the moving parts of the vehicle. Use existing wire channels, sills, panels and molding strips inside the vehicle to
hide the wiring for safety and a neat appliance.
·  Do not continuously use the subwoofer system beyond the nominal power handling capacity.
·  Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the subwoofer to
protect them from damage caused by the magnets in the subwoofer.
·  If you cannot find the appropriate mounting location, consult your car dealer or your nearest dealer before
mounting.
CAUTION: Take extreme caution when working near the gas tank, gas lines, brake or hydraulic lines and
electrical wiring.
2

Mounting the subwoofer
Installation kits are available from your dealer or local stereo shop to help make your installation easy. These
kits also give your installation a clean, custom appearance. Questions about installations methods please
consult a professional auto sound dealer/installer for assistance.
·   Choose the place of installation for the subwoofer. For most subwoofers stipulated regular places in the
automobile approach. In this case you need to know only assembly depth. Before installation the
subwoofer check up its assembly depth.
·   Clean any metal shavings from the mounting area and check for areas in which water may enter the
subwoofer cavity.  Treat the area for water protection when necessary.
If unit fails to operate properly
·   Carefully read the instruction to make sure the unit is being operated properly. Check the following before
you take your unit to the local dealer for repair.
SYMPTOM                  POSSIBLE CAUSE                              SOLUTION
No sound                 The volume control regulator set Adjust sound level
in the minimal position
The audio cassette receiver is Take your unit to the local dealer for
damaged                                     repair
Unnatural sound          Acoustic      system      cables      are Check to see that all the power and
connected without observance of speaker leads are securely connected
polarity (+ or -)
Damage speaker wire or speaker              Replace the speaker or speaker wires
The audio cassette receiver is Take your unit to the local dealer for
damaged                                     repair
NOTE: Good ground connections eliminate most electrical noise problems and require tight contact with the
metal vehicle chassis. Remove plastics, paint or rust for good electrical contact.
3