Сабвуфер SOUNDMAX SM-CSP10. Инструкция на русском языке

SM-CSP10
10” SUBWOOFER FOR SEALED TYPE BOX
10” (254 ??) ?KkO??o? O?? ??????K ?K?????o? ?j?K
Instruction manual
??????????? ?? ????????????

Description
x  Polypropylene cone                                                                          SM-CSP10
x  Rubber edge
x  Steel stamped basket
x  Antiresonance covering
Important safeguards
x  The owner’s manual contains important operating and maintenance instructions for your safety. It is
necessary to refer the manual.
x  Do not install the subwoofer where it may be subjected to excessive heat moisture, dust or where it will be
kicked repeatedly, brushed or bumped.
x  Make absolutely sure that the terminals for the subwoofer are connected to the proper outputs from the
music source.
x  Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or
the moving parts of the vehicle. Use existing wire channels, sills, panels and molding strips inside the vehicle to
hide the wiring for safety and a neat appliance.
x  Do not continuously use the subwoofer system beyond the nominal power handling capacity.
x  Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the subwoofer to
protect them from damage caused by the magnets in the subwoofer.
x  If you cannot find the appropriate mounting location, consult your car dealer or your nearest dealer before
mounting.
CAUTION: Take extreme caution when working near the gas tank, gas lines, brake or hydraulic lines and
electrical wiring.
2

Mounting the subwoofer
How to install
1.   Connect the speaker to the speaker cords.
Be sure to connect corresponding terminals
i.e. “Left” to “left”, “-” to “-”, etc.
2. ??   install the speaker in the trunk (behind the rear seat), use an audio board corresponding to the size of
trunk.
The subwoofer box should be mounted in an acoustical ducting assembled in the form of a cabinet with the
optimal volume 26 l. After assembling the cabinet and mounting the subwoofer you should test the hermeticity of
the assembly by slight pressing the cone. If you feel air resistance, it means that the assembly is of a good
quality and ready for exploitation. To improve the bass effect, it is recommended to paste over interior walls with
some fibrous material with thickness not more than 15 mm.
3