LED панель INVOLIGHT LED PANEL432. Инструкция на английском языке

LED Flood Light 432/10RGB
This device is lighting effect which can create decorative effects, it is designed for
professional use, e. g. on stages in disco club, theatres etc
A. SPECIFICATION
432 super bright leds:
Red: 18X8   Green: 18X8  Blue: 18X8
Red: 30000mcd,  Green: 30000mcd,   Blue: 20000mcd
Led beam angle: 30degree
Projector output distance: 30~35m
2X8 character LCD Display
selectable built-in programs, Auto running, DMX mode , slave mode,
sound-activated.
selectable 5. 8. 14. 26 DMX channel for different applications
Size: 54cm*19cm*7.5cm
Weight; 4.6g
Power in; 100V/240V 60HZ/50HZ
Power consumption; 50W
B.   1,the picture of front side
2, the picture of back side
C. OPERATION;
After opening the power, the LCD display will be as the follows:
1 of 1 pages

Press “MODE”button to activate the main menu: built-in program, Auto run, DMX mode,
Slave mode, sound mode.
built-in program-- running one of 14 built-in programs
Auto run—running built-in programs one after another in continuous loop.
DMX mode--controlled by DMX controller
Slave mode—the projectors in this mode will be synchronously run with the projectors in
master mode
Sound mode-- running by sound - activated
1. A program is a sequence of different steps, with LED flood light 432/10RGB yon can select
14 different Programs.  press“set up”and up/down buttons to select the programs (00-14) and
select the desired program value (step time, flash).
For example,
Press “setup”button to move the cursor to select 02 and the desired Sp (step time)or Fs (flash
speed)
Sp--step time value from 001-100
Fs--flash speed from 00-100
2.   Auto run
Running 14 programs in a continuous loop, the frequency means the running times. it can be
set up via the buttons up/down
3.   DMX mode
You can control the devices individually via your DMX-controller
1) Addressing
The control Board allows you to assign the DMX address which is defined as the first
channel from which the LED Flood light 432/10RGB will respond the controller. For address
setting, press “set up”buttons until the display shows as follows:
Set the desired address via the up/down buttons
2) DMX-PROTOCOL
2 of 2 pages

The control Board allows you to set 5. 8. 14. 26 DMX channel for different applications.
press“set up”button until the display is as follows:
Set the desired channels (5. 8. 14. 26) via the up/down buttons
?  set 26 channels
the  dimmer  occupies  the  first  channel  when  DMX  value  is  smaller  than  251,  the  flash
occupies the second channel, each spot occupies 3 channels, eight spots occupy 24 channels,
and the projector occupy 26 channels.
?Set 14channels
The  dimmer  occupies  the  first  channel  when  DMX  value  is  smaller  than  251,  the  flash
occupies the second channel, every 2 spots occupy 3 channels, eight spots occupy 12
channels, the projector occupies 14 channels
3 of 3 pages