Световой пульт, контроллер DMX INVOLIGHT DD6. Инструкция на английском языке

6CH LCD DIMMER PACK WITH SHUCKO
Thanks for purchasing 6CH LCD dimmer pack. This controller is 6-channel
dimmer pack with shucko socket. It can work alone or used as a DMX pack, as
well controlled by analog signal. When it works stand alone, there are 12
built-in program can be chosen, the speed can be adjusted When work as DMX
pack, it can be controlled by 1 to 6 channels, by address is between 001 to 512.
When it is under analog signal, it can be controlled by 6 channels signal in DC
0-10V The dimming is various in SWITCH, LINEAR, SQUARE As well, it has
the function of pre-heating, circuit brake protection, phase compensation, DMX
M/S, etc…Before operation, please carefully read this manual first. Thanks!
Parameter:
POWER SUPPLY----------------------------- SINGLE PHASE AC 220V 50-60HZ
3-PHASEAC      220V  50-60HZ
LOAD-------------------------------------------------------------------MAX:6*10A/CH
DMX OUTPUT------------------------------------------------3PIN female XLR socket
DMX INPUT-----------------------------------------------------3PIN male XLR socket
ANALOGUE INPUTS----------------------------------------DC 0-10V 8PIN D socket
DIMENSIONS------------------------------------------------------482mmX40mmX90mm
THE POWER SUPPLY ON-LINE DIAGRAM:
SINGLE PHASE AC220V 50-60HZ:
E                           L                        N
E       E               L3     L2      L1         N       N     N
3-PHASE     AC220V 50-60HZ:
E                  L3      L2       L1                 N
E       E               L3     L2       L1         N       N      N
1 of 1 pages

Operating instructions:
1,START MENU:
Connect to switch on power supply, first the LCD shows the edition number and start the automatic check in
alternate current, and then, The this time DMX instructions the light flash is slow. After completes. Enter to start
menu. (Meet the plank show the diagram) In start menu, the first each channel of manifestation front value, the
first each channel of manifestation inside the front changes the value of the channel; The second each channel of
manifestation preface number, the first each channel of manifestation inside front changes the preface number of
the channel. The LCD holds the above blue color instructions light to should bright degree in each channel.
DMX             1      2     3     4       5      6
2    1   2    3   4   5   6
CHANNEL
1       2       3        5       6
MENU       UP     DOWN      ESC
The front-panel shows the diagram
2. The factitiousness adjusts the light
2.1 The single channel factitiousness adjusts the light
Hold in the LCD bottom row contain six channel key, each key to should in its bottom
arithmetic figure a channel for meaning preface number. The key presses behind, to
should the channel value add/ reduce 1, be to add to 100%, then add 1, then for 0, be to
reduce to 0, then reduce 1, then for 100%;Keep on pressing down over two second, then
reduce 1, then quickly add/ reduce 1, its to should passage value as well circulate add/
reduce. LCD or the channel instructions can hold its value the light instructions
appearance. Add/ reduce the function be decided by the key of ESC, on the system
electricity empress, recognize tacitly for adding, Convert to add/ reduce function every
press once ESC key, henceforth.
2.2 All channels factitiousness adjusts the light:
Add:While    starting  the  menu,  it  is  each  to  press  once  Up  key  all  channels  adds  1,  be
some a the channel adds to 100% then stop the channel’s value add. Keep on pressing
down over two second, then add quickly 1, be some a the channel adds to 100% then
2 of 2 pages

stop the channel’s value add.
Reduce:While starting the menu, it is each to press once DOWN key all channels reduce
1, be some the channel reduces to 0 hours then stops the channel’s value reduces. Keep
on pressing down over two second, then reduce quickly 1, be some a the channel reduces
to 0 hours then stop the channel’s value reduces?
Note:  The factitiousness adjusts the light independence in other adjust the light, namely in course of
circulate the inside place a view, or suffers the control of DMX, or suffer the emulation signal control,
or prepare hot, move to adjust the light does not change other value, the passage outputs then with
they inside of the biggest value outputs.
2.3 FUNCTION MENU:
3.1 FIRST CLASS FUNCTION MENU:
While starting the menu, press MENU under“start”menu, then enter first-class function
menu, the LCD displays as following
Dmx fail
Press once UP/DOWN to circularly choose one of following six first-class functions in
the menu:Dmx fail?Dmx addr?preheating?Curve?preset?
Under the first-class function menu, press ESC to exit the function menu, enter to
“start”menu.
Under the first-class function menu, press MENU, Then enter the second-class
function menu.
3.2 Second-class function menu:
3.2.1  DMX FAIT menu
A. Under the DMX FAIL first-class function menu, press MENU and enter the second-class
function menu, it will display the current mode, if it is running built-in scene 8, it displays as
following:
3 of 3 pages