Архитектурная подсветка INVOLIGHT BATBAR600W. Инструкция на английском языке

INVOLIGHT BATBAR600W
USER MANUAL

Battery & Wireless DMX Outdoor Bar, 8*Tri-3W
User Manual
Our Battery & Wireless DMX Outdoor Bar offers very nice and bright effect as an architectural wall wash or for
performance stages where traditional stage lighting emits a lot of heat onto performers. Very smooth field with rich
palettes of color created by mixing the Red, Green and Blue LEDs. Please read the manual before operation.
A. SPECIFICATION
1. Voltage: AC 100V-240V, 60Hz/50Hz
2. Power Consumption: 40W
3. LED: 8*Tri-3W
4. Beam Angle: 40°C
5. Operation mode: LED display
6. Control Feature: Built-in programs, Auto running, DMX 512, Master/slave mode, Static color and Charge mode
7. DMX channels: 3, 5, 7 CH
8. IP Rate: IP 66
9. N.W: 4.46kgs
10. Dimension: 700*120*130 MM
11. Stand by time: 5.5 hours(RGB)
12. Charging time: 6.5 hours(LED blackout when the device is being charged)
B. OPERATION
This fixture is with rich effect programs, LED dislay for easier operation, there are six working modes:
?  Built-in programs mode
?  Auto running mode
?  Master/slave mode
?  DMX mode
?  Static color mode
?  Charge mode
Press the “MODE” button can switch the 6 working modes.
1.  Built-in Programs Mode
Pr.1        Static color program
Pr.2        Three colors fading
Pr.3        Seven colors fading

Pr.4        Three colors illusion
Pr.5       Three colors hopping
Pr.6       Seven colors hopping
Pr.7         Red color fading
Pr.8        Green color fading
Pr.9          Blue color fading
This mode is built-in programs mode, it is static color program when the display board shows  , then press
SETUP button to set the static colors via UP or DOWN buttons. Press “MODE” button again for more than 2s to
set the static color strobe value of the static colors via UP or DOWN buttons   -  .
Press “MODE” button for more than 2s could set the speed   -         and strobe value     -
when the display board shows     -
2.    Auto Running Mode
This mode is Auto Running mode, the fixture will automatically run the programs according to the preset programs
-      .
3.  Master/slave Mode
This mode is M/S Mode; the salve fixtures will follow the programs after they were linked to the master fixture via
DMX cables.
4.    DMX Mode
1) It is DMX mode when the display board shows     , the address could be set via UP and DOWN buttons,
the maximum value is 512.
2) Press the “MODE” button for more than 2s then release, enter into DMX working mode menu X-ch.
3) Press the “UP” or “DOWN” button, set the DMX working modes:   ,       ,       .
DMX mode 1:
CH1          CH2            CH3
R(0~255)     G(0~255)       B(0~255)
DMX mode 2:
CH1              CH2              CH3              CH4              CH5
R(0~255)         G(0~255)         B(0~255)      Dimmer(0~255)     Strobe(0~255)
DMX mode 3:
CH1      CH2    CH3     CH4          CH5               CH6          CH7
Dimmer      R      G       B          Program            Speed       Strobe
0~255  0~255  0~255  CH2-4
(R,G,B)
0-27(OFF)
28-55(R)
56-83(RG)
84-111(RG)
112-139(G)