Световой пульт, контроллер DMX INVOLIGHT AD8. Инструкция на английском языке

USER'S MANUAL
AD8
INTRODUCTION:
The unit is a  four channel power DMX dimmer  pack .  It is controlled by analog input from 0v to  10v
voltage  or DMX-512. It  provide  a  power supply for analog controller.  We  recommend  that  you take
time to read  this manual fully before you attempt to use the unit.
Specification:
Power input........................................................................Ac 230v ~50Hz , 16A.
Power output......................................................................Per channel  5 A, total 16A.
Analog input ......................................................................0---10v.
Power supply.....................................................................15V,500mA
DMX input........................................................................3pin XLR male socket
DMX output......................................................................3pin XLR female socket.
! !
Fuse ..................................................................................F 6.3A 250V,5X20MM. 4 purchase
! !
Circuit breaker .................................................................16A.
Dimension.........................................................................318x165x96mm
Weight...............................................................................2.95kg
Operation:
1. You must fixed the unit, then put the circuit breaker on off.  According to the diagram to connect the
analog controller or DMX controller .  Analog controller   with  8 pin  cable and DMX controller with
special cable .  Put the  output of controller  to minimum.
Analog input: DC  0-10V
DMX
RISK OF ELECTRIC SHOCKCTRIC SHOCK
RISK OF ELE
IN              Through
DMX IN       DMX OUT       1: GND
3            3 3                             DC +15V  500mA
2: DATA " - "       NC  NC               NC DC +15V  500mA
NC
3: DATA " + "
CH1   CH4            CH1   CH4
1     2      2     1                            CH2  CH3             CH2  CH3
GND                  GND
To analog controller
2. Connect  loading on output sockets .
3. All connection is ok ,you can  connect to  main power then turn on the circuit breaker .
4. To  adjust  the output of controller ,  the corresponding load from black to light.
FUNCTION
1  2  3  4  5  6  7  8  9   10
any one of DIP switch 1-9 is on, DMX parallel  1
DMX ADDRESS
All of DIP switch 1-9 is off, auto parallel
any one of DIP switch 1-9 is on ,DMX
1  2  4  8  16  32  64  128  256  Function  All  of DIP switch 1-9 is off , Auto
DMX ADDRESS
1  2  3  4  5  6  7  8  9  Start  address
1  0  0  0  0  0  0  0  0   1
5. DMX  controller and analog controller can     0  1  0  0  0  0  0  0  0   2
be used together. which single is stronger,  1  1  0  0  0  0  0  0  0   3
0  0  1  0  0  0  0  0  0   4
which single    control  output  loading.    1  0  1  0  0  0  0  0  0   5
1  1  1  1  1  1  1  1  1  511
1/2
PY-S242028

Power
CH4  CH3 CH2  CH1
DMX signal
It is blinking when the controller
is receiving DMX single.
! !  Caution:
1. To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.
2. This apparatus must be earthed.
3. Do not try to repair it when the circuit is out of order ,send back to you supplier for repairing.
2/2
PY-S242028