Стиральная машина HOTPOINT-ARISTON ARTXL 109. Инструкция на русском языке

Instructions for use
WASHING MACHINE
Contents                                            GB
Installation, 2-3
GB               ES              CIS                 Unpacking and levelling
Connecting the electricity and water supplies
English,1        Espanol,13      ???????, 25          The first wash cycle
Technical data
Care and maintenance, 4
I              GR               CZ                 Cutting off the water or electricity supply
Cleaning the washing machine
Italiano,37     AeecieeU, 49     Cesky,61            Caring for your appliance door and drum
Cleaning the pump
Checking the water inlet hose
How to clean the detergent dispenser
Precautions and tips, 5
General safety
Disposal
ARTXL 109                                             Saving energy and respecting the environment
Description of the washing machine
and starting a wash cycle, 6-7
Control panel
Indicator lights
How to open and shut the drum
Starting a wash cycle
Wash cycles, 8
Table of wash cycles
Personalisation, 9
Setting the temperature
Setting the spin speed
Functions
Detergents and laundry, 10
Detergent dispenser drawer
Bleach cycle
Preparing the laundry
Garments requiring special care
Load balancing system
Troubleshooting, 11
Service, 12
1

Installation
! Keep this instruction manual in a safe place for    If it is placed on a fitted or loose carpet, adjust
GB     future reference. Should the appliance be sold,       the feet in such a way as to allow enough room
transferred or moved, make sure the instruction       for ventilation beneath the washing machine.
manual accompanies the washing machine to             Putting  your  appliance  in  place  and
inform the new owner as to its operation and          moving it.
features.
If    your  washing
! Read these instructions carefully: they contain                              machine  is  equipped
vital information on installation, use and safety.                             with  a  special  set  of
retractable  wheels
Unpacking and levelling                                                        you can easy move it.
To  lower  the  wheels
Unpacking                                                                      and  thus  move  the
1. Unpack the washing machine.                                                 appliance  effortlessly,
2. Check whether the washing machine has been                                  just  pull  the  lever,
damaged during transport. If this is the case, do                              situated  on  the  left-
not install it and contact your retailer.             hand side beneath the base. Once the appliance
3. Remove the four pro-    is in the required position, put the lever back in
tective screws and the     place. The washing machine is now firmly in
rubber washer with the     place (see figure).
respective spacer, si-     Electric and water connections
tuated on the rear of the
appliance (see figure).    Connecting the water inlet hose
4. Seal the gaps using the
plastic plugs provided.                             1. Connect the supply
5. Keep all the parts: you                          pipe by screwing it to
will need them again if                             a cold water tab using
the  washing  machine                               a ? gas threaded con-
needs to be moved to                                nection (see figure).
another location.                                   Before performing the
Warning:  should  the                               connection, allow the
screws  be  re-used,                                water to run freely until
make sure you fasten                                it is perfectly clear.
the shorter ones at the top.
! Packaging materials are not children’s toys.                                 2.  Connect  the  other
Levelling                                                                      end of the water inlet
1. Install the washing machine on a flat sturdy                                hose  to  the  washing
machine,
floor, without resting it up against walls, furniture                          screwing it onto the ap-
cabinets or other.                                                             pliance’s cold water in-
2. If the floor is not per-                          let, situated on the top
fectly level, compensate                             right-hand side on the
for any unevenness by                                rear  of  the  appliance
tightening or loosening                              (see figure).
the adjustable front feet
(see  figure);  the  angle   3. Make sure there are no kinks or bends in the
of  inclination,  measu-    hose.
red  according  to  the     ! The water pressure at the tap must be within
worktop, must not ex-         the values indicated in the Technical details
ceed 2°.                      table (on the next page).
Levelling your appliance    ! If  the  water  inlet  hose  is  not  long  enough,
correctly will provide it with stability and avoid any   contact  a  specialist  store  or  an  authorised
vibrations, noise and shifting during operation.        serviceman.
! Never use hoses that have already been used.
2

Connecting the drain hose                             ! Do not use extension cords or multiple sockets.   GB
Connect the drain           ! The cable should not be bent or compressed.
hose, without bending
it, to a drainage duct      ! The power supply cable must only be replaced
or a wall drain located     by authorised technicians.
at a height between
65 - 100 cm           65 and 100 cm from          Warning! The company shall not be held respon-
the floor;                  sible in the event that these regulations are not
respected.
The first wash cycle
alternatively, rest it on
the side of a washba-       Once  the  appliance  has  been  installed,  and
sin or bathtub, faste-      before you use it for the first time, run a wash
ning the duct sup-          cycle with detergent and no laundry, using the
plied to the tap (see       wash cycle      .
figure). The free end
of the hose should
not be underwater.           Technical data
Model            ARTXL 109
! We advise against the use of hose extensions;        Dimensions       width 40 cm
height 85 cm
if it is absolutely necessary, the extension must                       depth 60 cm
have the same diameter as the original hose and
must not exceed 150 cm in length.                      Capacity         from 1 to 6 kg
Electrical connections                                 Electrical       please refer to the technical
data plate fixed to the ma-
connections      chine
Before plugging the appliance into the electricity                      maximum pressure
socket, make sure that:                                                 1 MPa (10 bar)
Water con-       minimum pressure
• the socket is earthed and complies with all          nections         0.05 MPa (0.5 bar)
applicable laws;                                                      drum capacity 42 litres
• the socket is able to withstand the maximum          Spin speed       up to 1000 rotations per
minute
power load of the appliance as indicated in the
Technical data table (see opposite);                 Test wash
cycles in
• the power supply voltage falls within the va-        accordan-        Programme        ;
Cotton Standard 60°C.
lues indicated in the Technical data table (see      ce with          Programme        ;
opposite);                                           directives       Cotton Standard 40°C.
1061/2010
• the socket is compatible with the plug of the        1015/2010
washing machine. If this is not the case, repla-
ce the socket or the plug.                                            This appliance conforms to
the following EC Directives:
! The washing machine must not be installed                             - 2004/108/EC (Electroma-
outdoors, even in covered areas. It is extremely                        gnetic Compatibility)
dangerous to leave the appliance exposed to                             - 2006/95/EC (Low Voltage)
rain, storms and other weather conditions.                              - 2002/96/EC
! When the washing machine has been installed,
the electricity socket must be within easy reach.
3