На сайте 124097 инструкций общим размером 502.36 Гб , которые состоят из 6272799 страниц
Руководство пользователя VITEK VT-1198. Основные функции, характеристики и условия эксплуатации изложены на 28 страницах документа в pdf формате.
Доступно к просмотру 28 страниц. Рекомендуем вам скачать файл инструкции, поскольку онлайн просмотр документа может сильно отличаться от оригинала.
VT-1198 ST Аppliance for heating liquids (thermopot) Прибор для нагревания жидкости (термопот) 3 7 12 17 22 1 VT-1198.indd 1 18.09.2015 12:56:37
VT-1198.indd 2 18.09.2015 12:56:37
ENGLISH APPLIANCE FOR HEATING LIQUIDS VT-1198 ST Use the unit for intended purposes only, as speci- The appliance for heating liquids (thermopot) is fied in this instruction manual. Mishandling the intended for boiling water only. For proper and unit can lead to its breakage and cause harm to safe use of the unit read these instructions care- the user or damage to his/her property. fully. • Make sure that the operating voltage of the unit corresponds to the voltage of your mains. DESCRIPTION • The power cord is equipped with a «euro- 1. Low water level mark «MIN» plug»; plug it into the socket with a reliable 2. Illuminated water level scale grounding contact. 3. Lower water dispensing button • To avoid the risk of electric shock, do not use 4. Spout for water pouring adapters for connecting the unit to the mains. 5. Display • Do not use the unit in bathrooms. Do not use 6. Control panel it near swimming pools or other containers 7. Upper water dispensing button filled with water. 8. Lid opening button • Do not use the thermopot near heat sources 9. Steam release openings or open flame. 10. Lock • Place the thermopot on a flat stable surface; 11. Removable upper lid do not place the unit on the edge of the table. 12. Carrying handle • Do not place the unit near walls or furniture, 13. Lid axis the distance between the unit and any other 14. Maximal water level mark «FULL» surface should be at least 30 cm. 15. Body • Do not use the unit outdoors. 16. Power cord connection socket • Do not connect or disconnect the power cord 17. Power cord with wet hands, this may cause electric shock 18. Rotary base or injuries. • Make sure that the power cord does not hang Control panel from the edge of the table or touch hot sur- 19. Water boiling/re-boiling ON-button «Boil/Stop» faces. 20. Heating temperature selection button • When unplugging the unit, pull the plug but «Temperature selection» not the cord. 21. Water boiling mode/temperature mainte- • Do not switch the unit on without water. nance mode indicator • Use the thermopot only for water boiling; it 22. Power saving mode indicator is prohibited to heat or boil other liquids in it. 23. Light sensor • Ensure that the water level is not below the 24. Unlocked water dispensing indicator minimal mark and not above the maximal 25. Delayed start button «Delayed start» mark. 26. Water dispensing lock/unlock button • Do not refill the thermopot during boiling or «Unlock» right after it. • Do not fill the thermopot with water directly Display from the faucet; to fill the thermopot use a 27. Water temperature indication suitable bowl. 28. Delayed start time indication • Do not drop, overturn or tilt the unit. 29. Set water temperature indication • Do not leave the operating unit unattended. • Do not open the lid and do not dispense water ATTENTION! during boiling. For additional protection it is reasonable to install • Do not rotate the unit from side to side when a residual current device (RCD) with nominal turning water dispensing on. operation current not exceeding 30 mA, to install • Close the lid properly, but without excessive RCD, contact a specialist. effort. • Keep your hands away from steam release SAFETY MEASURES openings and do not bend over them, it may Before using the thermopot, read this instruction cause scalding. Do not block the steam manual carefully and keep it for future reference. release openings with any foreign objects. 3 VT-1198.indd 3 18.09.2015 12:56:38