Духовой шкаф WHIRLPOOL AKP 212 IX. Инструкция на русском языке

(Apply the label from warranty here)
User and maintenance manual
Instrukcja obslugi i konserwacji
Navod k pouziti a udrzbe
Navod na pouzivanie a udrzbu
Felhasznaloi es karbantartasi kezikonyv
RU    Руководство по эксплуатации и техобслуживанию
RO    Manual de utilizare si intretinere

IMPORTANT SAFETY INSTRUCTIONS
YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT
This manual and the appliance itself provide important safety warnings, to be read and observed at all times.
This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
All safety warnings are preceded by the danger symbol and the following terms:
Indicates a hazardous situation which, if not avoided, will cause serious injury.
DANGER
Indicates a hazardous situation which, if not avoided, could cause serious injury.
WARNING
All safety warnings give specific details of the potential risk present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use
of the appliance. Carefully observe the following instructions:
-  The appliance must be disconnected from the power supply before carrying out any installation work.
-  Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations. Do
not repair or replace any part of the appliance unless specifically stated in the user manual.
-  Regulations require that the appliance is earthed.
-  The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply socket.
-  For installation to comply with current safety regulations, an all-pole disconnect switch with minimum contact gap of 3 mm must be utilized.
-  Do not use multiple plug adapters or extension leads.
-  Do not pull the power supply cable in order to unplug the appliance.
-  The electrical components must not be accessible to the user after installation.
-  Do not touch the appliance with any wet part of the body and do not operate it when barefoot.
-  This appliance is designed solely for use as a domestic appliance for cooking food. No other type of use is permitted (e.g.: heating rooms). The Manufacturer
declines all responsibility for inappropriate use or incorrect setting of the controls.
-  The appliance is not intended for use by persons (including children) with any physical, sensory or mental impairment, or without experience and knowledge of
the appliance, unless supervised or previously instructed in its use by those responsible for their safety.
-  The accessible parts of the appliance may become very hot during use. Young children should be kept away from the appliance and supervised to ensure that they
do not play with it.
-  During and after use, do not touch the heating elements or interior surfaces of the appliance - risk of burns. Do not allow the appliance to come into contact with
cloths or other flammable materials until all the components have cooled sufficiently.
-  At the end of cooking, exercise caution when opening the appliance door, letting the hot air or steam exit gradually before accessing the oven. When the
appliance door is shut, hot air is vented from the aperture above the control panel. Do not obstruct the vent apertures.
-  Use oven gloves to remove pans and accessories, taking care not to touch the heating elements.
-  Do not place flammable materials in or near the appliance: a fire may break out if the appliance is inadvertently switched on.
-  Do not heat or cook sealed jars or containers in the appliance. The pressure that builds up inside might cause the jar to explode, damaging the appliance.
-  Do not use containers made of synthetic materials.
-  Overheated oils and fats catch fire easily. Always remain vigilant when cooking foods rich in fat and oil.
-  Never leave the appliance unattended during food drying.
-  If alcoholic beverages are used when cooking foods (e.g. rum, cognac, wine), remember that alcohol evaporates at high temperatures. As a result, there is a risk
that vapours released by the alcohol may catch fire upon coming into contact with the electrical heating element.
Scrapping of household appliances
-  This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off
the power supply cable.
-  For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service
for household waste or the store where you purchased the appliance.
GB2

INSTALLATION
After unpacking the oven, be sure  that it has not been damaged during transport and that the oven door closes properly. In the event of problems, contact the dealer
or your nearest After-sales Service. To avoid any damage, only remove the oven from its polystyrene foam base at the time of installation.
PREPARING THE HOUSING UNIT
•  Kitchen units in contact with the oven must be heat resistant (min 90°C).
•  Carry out all cabinet cutting work before fitting the oven in the housing and carefully remove all wood chips and sawdust.
•  After installation, the bottom of the oven must no longer be accessible.
•  For correct appliance operation, do not obstruct the minimum gap between the worktop and the upper edge of the oven.
ELECTRICAL CONNECTION
Be sure the power voltage specified on the appliance dataplate is the same as the mains voltage. The dataplate is on the front edge of the oven (visible when the door
is open).
2
•  Power cable replacement (type H05 RR-F 3 x 1.5 mm ) must be carried out by a qualified electrician. Contact an authorized service centre.
GENERAL RECOMMENDATIONS
Before use:
-  Remove cardboard protection pieces, protective film and adhesive labels from accessories.
-  Remove the accessories from the oven and heat it at 200° for about an hour to eliminate the smell and fumes from the insulating materials and protective grease.
During use:
-  Do not place heavy objects on the door as they could damage it.
-  Do not cling to the door or hang anything from the handle.
-  Do not cover the inside of the oven with aluminium foil.
-  Do not pour water into the inside of a hot oven; this could damage the enamel coating.
-  Do not drag pots or pans across the bottom of the oven as this could damage the enamel coating.
-  Be sure that the electrical cables of other appliances do not touch hot parts of the oven or become trapped in the door.
-  Do not expose the oven to atmospheric agents.
SAFEGUARDING THE ENVIRONMENT
Disposal of packing material
The packing material is 100% recyclable and is marked with the recycle symbol (  ). The various parts of the packing must therefore be disposed of responsibly and
in full compliance with local authority regulations governing waste disposal.
Scrapping the product
-  This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
-  By ensuring this product is disposed of correctly, you will help avoid potential negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product.
-  The symbol    on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an
appropriate collection centre for the recycling of electrical and electronic equipment.
Energy saving
-  Only pre-heat the oven if specified in the cooking table or your recipe.
-  Use dark lacquered or enamelled baking moulds as they absorb heat far better.
-  Switch the oven off 10/15 minutes before the set cooking time. Food requiring prolonged cooking will continue to cook even once the oven is switched off.
DECLARATION OF CONFORMITY
-  This oven, which is intended to come into contact with foodstuffs, complies with European Regulation (  ) n. 1935/2004 and has been designed,
manufactured and sold in conformity with the safety requirements of the “Low Voltage” directive 2006/95/CE (which replaces 73/23/CEE and subsequent
amendments), the protection requirements of “EMC” 2004/108/CE.
GB3