Плита INDESIT 7OFIM 53K.A IX. Инструкция на русском языке

Operating Instructions
OVEN
Contents
GB
Installation, 2-3
GB            RS                                Positioning
Electrical connections
English,1      Русский, 11                       Data plate
Description of the appliance, 4
Overall view
Control panel
Start-up and use, 5
Starting the oven
Assistance
Cooking modes, 6-7
Cooking modes
Practical cooking advice
Cooking advice table
7OFIM 53 K.A
7OFIM 53 K.A IX                                  The electronic cooking programmer, 8
7OFIMS 53 K.A
7OFIMS 53K.A IX                                  Precautions and tips, 9
General safety
Disposal
Respecting and conserving the environment
Maintenance and care, 10
Switching the appliance off
Cleaning the appliance
Cleaning the oven door
Replacing the light bulb

Installation
! Before placing your new appliance into operation   Ventilation
GB      please read these operating instructions carefully.
They contain important information for safe use, for  To ensure good ventilation, the back panel of the
installation and for care of the appliance.          cabinet must be removed. It is advisable to install the
oven so that it rests on two strips of wood, or on a
! Please keep these operating instructions for future  completely flat surface with an opening of at least 45 x
reference. Pass them on to possible new owners of    560 mm (see diagrams).
the appliance.
Positioning                                                                       45 mm.
560 mm.
! Keep packaging material out of the reach of
children. It can become a choking or suffocation
hazard. (see Precautions and tips).
! The appliance must be installed by a qualified
person in compliance with the instructions provided.
Incorrect installation may cause harm to persons,    Centring and fastening
animals or may damage property.
Secure the appliance to the cabinet by opening the
Fitting the appliance                                oven door and putting 4 screws into the 4 holes of the
outer frame.
Use the appropriate cabinet to ensure that the
appliance functions properly.
• The panels adjacent to the oven must be made of
heat-resistant material.
• Cabinets with a veneer exterior must be assembled
with glues which can withstand temperatures of up
to 100°C.
•  to install the oven under the counter (see diagram)
and in a kitchen unit, the cabinet must have the
following dimensions:
! All parts which ensure the safe operation of the
appliance must not be removable without the aid of a
tool.
547 mm. min.
23 mm.    45 mm.
595 mm.         567 mm.  560 mm.  575-585 mm.
5 mm.
545 mm.
595 mm.
24 mm.
! The appliance must not come into contact with
electrical parts once it has been installed.
The consumption indications on the data plate have
been calculated for this type of installation.
2

Electrical connections                                 plate (see below).
GB
• The voltage must be in the range between the
! Ovens equipped with a three-pole power supply        values indicated on the data plate (see below).
cable are designed to operate with alternating current  • The socket is compatible with the plug of the
at the voltage and frequency indicated on the data     appliance. If the socket is incompatible with the
plate located on the appliance (see below).            plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
Fitting the power supply cable
! Once the appliance has been installed, the power
1. Open the terminal
supply cable and the electrical socket must be easily
board by inserting a
accessible.
screwdriver into the
! The cable must not be bent or compressed.
side tabs of the cover.
! The cable must be checked regularly and replaced
Use the screwdriver as
by authorised technicians only (see Assistance).
a lever by pushing it
! The manufacturer declines any liability should
down to open the cover
these safety measures not be observed.
(see diagram).
2. Loosen the cable
DATA PLATE
clamp screw and
remove it, using a                            width cm 43.5
screwdriver as a lever      Dimensions        height cm 32
depth cm 40
(see figure).
3. Remove the wire          Volume            lt. 56
contact screws L-N-                           voltage: 220-240V ~ 50/60 Hz
, then fasten the wires     Electrical        (see data plate)
under the screw heads,      connections
maximum power absorbed 2250W
respecting the colour
Directive 2002/40/EC on the label
code: Blue (N), Brown                         of electric ovens.
(L) and Yellow-Green                          Standard EN 50304
Verde (  ).
Models with cooling ventilation:
Energy consumption for Natural
Connecting the supply cable to the mains                               convection heating mode:
Convection
Install a standardised plug corresponding to the load                  Declared energy consumption for
indicated on the data plate (see side).                                Forced convection Class heating
ENERGY LABEL      mode:              Multi-cooking
The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a                        Models    without    cooling
minimum contact opening of 3 mm installed between                      ventilation:
the appliance and the mains, suitable for the load                     Energy consumption for Forced
indicated and complying with current electrical                        convection heating mode:
regulations (the earthing wire must not be interrupted                 Multi-cooking
Declared energy consumption for
by the circuit-breaker). The supply cable must not
Natural convection Class heating
come into contact with surfaces with temperatures                      mode:             Convection
higher than 50°C.
This appliance conforms to the
! The installer must ensure that the correct electrical                following European Economic
Community directives:
connection has been made and that it is compliant
2006/95/EEC of 12/12/06 (Low
with safety regulations.                                               Voltage) and subsequent
amendments;
Before connecting to the power supply, make sure                       -2004/108/EEC of 15/12/04
that:                                                                  (Electromagnetic Compatibility) and
• The appliance is earthed and the plug is                             subsequent amendments;
compliant with the law.                                              93/68/EEC of 22/07/93 and
subsequent amendments.
• The socket can withstand the maximum power of
2002/96/EC and subsequent
the appliance, which is indicated on the data
amendments.
3