Водонагреватель накопительный TIMBERK SWH MS2 10 HU. Инструкция на русском языке

Instruction manual
Electrical
storage water
heater
SWH MS2 10H / SWH MS2 10H series
RS2 / RS2 series                                       / Models
SWH RS1 30 V         SWH RS2 30 H
SWH RS1 50 V         SWH RS2 50 H
SWH RS1 80 V         SWH RS2 80 H
SWH RS1 100 V
SWH RS7 30 V
SWH RS7 40 V
SWH MS2 10 H         SWH RS7 50 V
RS7 / RS7 series        RS1 / RS1 series
.
Outlook of devices, aslo colour scores can be revised without any special advance notices.

1.  Important information
2.  Precautions
3.  Performance parameters
Technical characteristics
Dimensional features
4.  Water heater description
5.  Scope of delivery
6.  Water heater installation
Location
Water heater mounting methods
Water heater mounting
Connection to water main
Connection to electric mains
Ground Fault Circuit Interrupted (GFCI)
7.  Water heater control
8.  Water heater operation
9.  Maintence
10.  Troubleshooting
11.  Wiring diagram
12.  Disposal
www.timberk.com    electrical storage water heater

ENGLISH
3. Connect the water heater only to 230V, 50Hz main. If necessary, find   18. It is forbidden to make alterations in the design of the water heater
out parameters of your mains at power suppliers.     or modify it.
4. To prevent overheating and risk of fire, as well as damage of internal   19. Any service operations must be performed by a specialized
electrical main, do no modify the power cord's length and do no   organisation and qualified specialists. Improper installation may cause
connect the water heater through electrical extenders.  voiding of guarantee maintenance.
5. It is forbidden to switch on the water heater if it is not filled with water   20. The water heater is not intended for use by children and persons
or if water cannot go through a pressure safety valve.  with reduced physical, sensory or mental capabilities, or a lack of
experience and knowledge, unless they have been given supervision or
6. Never use the water heater if it is broken.
instruction concerning use of the appliance by an individual responsible
7. Do not remove the water heater cover when it is in operation.  for their safety. Children should be supervised to ensure that they do not
play with the appliance.
8. Immediately unplug the water heater from electrical main if strange
sounds, odor or smoke are coming from it.
9. Always unplug the water heater from electrical main during a   3. PERFORMANCE PARAMETERS
thunderstorm.
1. Completely automatic control: automatic water heating, continuous
10. Prior to cleaning and maintenance of the water heater unplug it from   automatic water temperature control.
electrical main. Cleaning and maintenance must be performed in
compliance with instructions of this operation manual.  2.  3D Logic® three-stage protection system:
11. Do not use hazardous chemical substances to clean the water heater   DROP Defense   leakage protection and protection against surplus
and prevent their contact with the appliance.         pressure within a tank (pressure safety valve)
12. To prevent electrical shock the damaged power cord must be   SHOCK Defense   current leakage protection (GFCI is built in the plug
replaced only in manufacturer's authorized service centers by qualified   of appliance's power cord)
specialists.
HOT Defense   two-stage overheating protection (thermostat and
13. To prevent electrical shock do not place the power cord nearby   temperature limiter)
heating devices and flammables or combustibles.      ALL PROTECTION SYSTEMS ARE RELIABLE AND SAFE.
14. Do not press buttons on the control panel of the water heater and its   3. Pipes of heating elements are designed taking into account high heat
remote controller (for some models) otherwise but by your fingers.
load: safe and reliable, with an increased service life.
15. Since temperature of water in the water heater can reach 75°C, when   4. NON CFC urethane foam insulation of increased thickness: excellent
it is in operation you should not place your body parts under hot water   heat insulation that allows to efficiently retain accumulated heat and
at the first run.
save energy.
To prevent burns you should adjust the temperature of the discharging   5. Temperature controller: accurate and reliable water temperature
water.
control.
16. Do not use the water heater for purposes not specified by this   6. Internal tanks and all internal components are made out of SUS 304
operation manual.
stainless steel with walls 1.2 mm thick.
17. Do not use the water heater in an explosive or corrosive   7. Magnesium anode is for additional protection of the tank and seam
environment. Do not store gas and other volatile flammable liquids next   joints.
to the appliance   it is very dangerous!
www.timberk.com    electrical  storage water heater  3