Кондиционер SAMSUNG AW05B0LA (AW0519). Инструкция на русском языке

Y
Corrective action
connections
N
Problem?
Samsung Electronics
and terminals for
Inspect electrical
wiring for defects,
correct and secure
Y
Add oil as necessary
AW-05B0LA(AW0519)-1  11/27/98 2:05 PM  Page 4-1
Solder discharge line
Low oil level?
4. Disassembly and Reassembly
Check refrigerant oil level
from compressor
from compressor
Release refrigerant
4-1 Compressor Replacement Flow Chart
Cut refrigerant lines
Replace compressor
Locate cause of defect
Plug disconnected lines
N
Disconnect electrical wiring
Solder suction line
Use nitrogen gas
N
Leakage?
Evacuate system
Check for leakage
Recharge system
Release nitrogen gas?
Y
Pinch and braze filling tube
Perform soldering function
Fill system with nitrogen gas
4-1

4-2
4.
5.
6.
1.
2.
3.
Normal
Overheat
Condition of
4-2-1 Oil quality
Model
Motor Damage
Refrigerant Cycle
AW05B0LA(AW0519)
4-2 Checking the Oil
Change the condenser .... add 50cc
Change the evaporator .... add 50cc
AW-05B0LA(AW0519)-1  11/27/98 2:05 PM  Page 4-2
(unless the oil has leaked significantly).
already charged.
When the refrigerant is replaced .... add 30cc oil.
Color
Dark Brown
Brown Color
Light Yellow
4-3 Refrigerant Oil Specifications
4-2-2 Changing and adding refrigerant oil
Put approximately 10cc oil into a transparent container and test it.
SONTEX 200LT
Oil Specification
Condition of Oil
In the event of a refrigerant leak, generally it is not necessary to add oil
After vacuum is completed, the oil is filled through the high pressure side.
Change the compressor - DO NOT recharge the oil as the compressor itself is
-
Odor
No Odor
Pungent Oil
280CC
Oil Change
Remarks
Oil Change
Oil Change
Return with the system
Samsung Electronics

?
`
‹
?
No.
Ass'y - Grille
Samsung Electronics
Ass'y - Frame
Ass'y - Blower
Ass'y - Evaporator
Part name
AW-05B0LA(AW0519)-1  11/27/98 2:05 PM  Page 4-3
and lift the cabinet upward.
Procedures
located behind the knob on right.
remove screw on top of right side.
then lift the grille off the top latches.
3. Separate the evaporator from the unit.
1. Remove the knobs and the grille screw
1. Remove foam-seal on the top of the unit.
1. Loose the bolt to disassemble the blower.
2. After unfolding evaporator cover upwardly,
1. Remove the 8 screws on each of the cabinet
in on the grille tabs on both cabinet sides, and
2. Remove the grille from the cabinet by pushing
4-4 Disassembly and Reassembly Procedure
Remarks
Stop operating of the air conditioner and remove the power cord before repairing the unit.
4-3