Масляный радиатор MARTA MT-2428. Инструкция на русском языке

OIL HEATER
Instruction manual
МАСЛЯНЫЙ РАДИАТОР ОТОПЛЕНИЯ
Руководство по эксплуатации
MT-2428

DESCRIPTION
1.  Front cover
2.  Integrated handle
3.  Pilot lamp
4.  Thermostat knob
5.  Power switch knob
6.  Cord wrap
7.  Heater units
8.  Wheels
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed, including the following:
To ensure familiarity with the controls, safety features, and operation of your heater, read all instructions before use.
To reduce hazard of injury due to electric shock:
-      Danger of electric shock exists even when the appliance is switched off. ALWAYS unplug the unit when not in use.
-      Heater should never be used under conditions where it may be immersed, or come in contact with water. Similarly do not plug in your heater if its surfaces
are damp.
-      Do not operate the heater with a damaged cord set, or if it has been dropped, or damaged in any manner. Return it to an Authorized Service center for
inspection, repairing and testing.
-      Close supervision is required when any appliance is used by or near children.
-      Disconnect the cord from the outlet before cleaning.
-      Unplug heater by grasping plug and pulling it from the outlet. NEVER YANK ON CORD.
-      When store your heater, keep it in a cool, dry place.
2

WARNING:
The surface temperature of the flanges is higher, during use, thus closely supervise any children in the area of this appliance.
Do not use on a wet place to prevent electrical shock.
Do not leave the cable on hot surfaces.
Do not use outdoors.
If malfunctions happen during operation, please put it to nearby appointed service center with the maintenance card. Never disassemble it by yourself.
Be sure to pull out the plug from an outlet when not in use and before cleaning.
DO NOT OPERATE WITHOUT CASTORS ATTACHED!
CAUTION! Do not cover the oil heater while it is on. This can cause dangerous temperature increase.
ASSEMBLING
Carefully turn the oil heater upside down on a carpet or any other soft surface, in order to avoid damaging the protective layer.
Put two wheels and supporting plate assemblies on the unit and insert the “U” shape screw into two holes of the supporting plate.
Insert the butterfly nuts and screw them tightly counter clockwise.
3