Встраиваемая вытяжка ZIGMUND SHTAIN K 002.61 X. Инструкция на русском языке

GB   COOKER HOOD - User instructions
CZ   ODSAVAC PAR - Navod k pouziti
DK   EMH?TTE - Brugervejledning
FIN  LIESITUULETIN - Kayttoohje
GR   ????????????? ?? ?????? ??????????? – ?????????? ??????
H   ELSZIVO KURTO - Hasznalati utasitas
N   AVTREKKSKAPPE - Bruksanvisning
PL  OKAP ZASYSAJACY - Instrukcja obslugi
R   HOTA ASPIRANTA - Manual de utilizare
RUS  ВЫТЯЖНОЙ КОЛПАК - Руководство пользователя
S   SPISKAPA - Bruksanvisning

ENGLISH           GB      electrician.
- If the power supply cable is damaged, it must be replaced
with another cable or a special assembly, which may be
obtained direct from the manufacturer or from the Technical
GENERAL                             Assistance Centre.
- This device must be connected to the supply network
Carefully read the following important information regarding   through either a plug fused 3A or hardwired to a 2 fase spur
installation safety and maintenance. Keep this information   protected by 3A fuse.
booklet accessible for further consultations. The appliance
has been designed for use in the ducting version (air exhaust   2. Warning!
to the outside - Fig.3A), filtering version (air circulation on the   In certain circumstances electrical appliances may be a
inside - Fig.3B) or with external motor (Fig.3C).  danger hazard.
A) Do not check the status of the filters while the cooker
SAFETY PRECAUTION                   hood is operating.
B) Do not touch bulbs or adjacent areas, during or straight
1. Take care when the cooker hood is operating simultane-  after prolonged use of the lighting installation.
ously with an open fireplace or burner that depend on the air   C) Flambe cooking is prohibited underneath the cooker
in the environment and are supplied by other than electrical   hood.
energy, as the cooker hood removes the air from the environ-  D) Avoid free flame, as it is damaging for the filters and a
ment which a burner or fireplace need for combustion. The   fire hazard.
negative pressure in the environment must not exceed 4Pa   E) Constantly check food frying to avoid that the over-
(4x10-5 bar). Provide adequate ventilation in the environment   heated oil may become a fire hazard.
for a safe operation of the cooker hood. Follow the local laws   F) Disconnect the electrical plug prior to any maintenance.
applicable for external air evacuation.  G) This appliance is not intended for use by young children
or infirm persons without supervision.
Before connecting the model to the electricity network:  H) Young children should be supervised to ensure they do
- Control the data plate (positioned inside the appliance)   not play with the appliance.
to ascertain that the voltage and power correspond to the   I)  There shall be adequate ventilation of the room when
network and the socket is suitable. If in doubt ask a qualified   the rangehood is used at the same time as appliances
- 4 -

burning gas or other fuels.          correct installation of the cooker hood:
L)  There is a risk of fire if cleaning is not carried out in   1. Mounting of the cooker hood on the lower side of the
accordance with the instructions.    cupboard.
2. Selection of the version (extraction Fig.3A or filtration
This appliance conforms to the European Directive EC/2002/96,   Fig.3B).
Waste Electrical and Electronic Equipment (WEEE). By making
sure that this appliance is disposed of in a suitable manner, the   •  Fixing the hood to the lower part of the wall cabinet:
user is helping to prevent potential damage to the environ-  This type of appliance must be fitted inside a cabinet or inside
ment or to public health.            another type of support structure. To fix it in place, use 4 screws
which are suitable for the type of cabinet, making holes in ac-
The symbol on the product or on the accompanying   cordance with the diagram shown in Fig.1. To fit the appliance
paperwork indicates that the appliance should not be   correctly, align the front panel of the cooker hood with the
treated as domestic waste, but should be delivered to   cabinet door and adjust spacer L using screws P (Fig.2), then
a suitable electric and electronic appliance recycling collection   ensure the appliance meets the cabinet at the rear.
point. Follow local guidelines when disposing of waste. For
more information on the treatment, re-use and recycling of   •  Extraction through an outside wall:
this product, please contact your local authority, domestic   The appliance expels the fumes through an outside wall or
waste collection service or the shop where the appliance was   a duct. It is necessary to buy a telescopic pipe in accordance
purchased.                           with the standards in use (inflammable) and connect it to
flange H (Fig.3A).
INSTALLATION INSTRUCTIONS
•  Recirculation:
•  Assembly and electrical connections must be carried out   To transform the cooker hood from the extraction version to
by specialised personnel.            the re circulating one ask your supplier for an activated carbon
•  Wear protective gloves before proceeding with the   filter. The filter must be fitted to the extracting group cooker
installation.                        hood in the centre of the fan grille by twisting it by 90 degrees
until it is gripped securely (Fig.5). For this operation remove the
•  Electric Connection:              anti-grease filter(s) G (Fig.4). The clean air is returned into the
- The appliance has been manufactured as a class II, therefore   room through a connecting tube passing inside the cupboard
no earth cable is necessary. The plug must be easily acces-  and connected to the ring H (Fig.3B).
sible after the installation of the appliance. If the appliance
is equipped with power cord without plug, a suitably di-   USE AND MAINTENANCE
mensioned omnipolar switch with 3 mm minimum opening
between contacts must be fitted between the appliance and   •  We recommend that the cooker hood is switched on before
the electricity supply in compliance with the load and current   any food is cooked. We also recommend that the appliance is
regulations.                         left running for 15 minutes after the food is cooked, in order
- The connection to the mains is carried out as follows:  to thoroughly eliminate all contaminated air. The effective
BROWN = L line                       performance of the cooker hood depends on constant main-
BLUE = N neutral.                    tenance; the anti-grease filter and the active carbon filter both
require special attention.
•  If the hob is electric, gas, or induction, the minimum distance   •  The anti-grease filter is responsible retaining the grease
between the same and the lower part of the hood must be   particles suspended in the air, therefore it is subject to clog-
at least 65 cm. If a connection tube composed of two parts is   ging with variable frequency according to the use of the
used, the upper part must be placed outside the lower part.   appliance.
Do not connect the cooker hood exhaust to the same con-  -  To prevent the danger of possible fires, at least every 2
ductor used to circulate hot air or for evacuating fumes from   months one must wash the anti-grease filters by hand using
other appliances generated by other than an electrical source.   non-abrasive neutral liquid detergents or in the dishwasher
Before proceeding with the assembly operations, remove the   at low temperatures and on short cycles.
anti-grease filter(s) (Fig.4) so that the unit is easier to handle.  -  After a few washes, colour alterations may occur. This does
-  In the case of assembly of the appliance in the suction version   not give the right to claim their replacement.
prepare the hole for evacuation of the air.  •  The active carbon filters are used to purify the air that is
sent back into the room and its function is to mitigate the
•  We recommend the use of an air exhaust tube which has the   unpleasant odours produced by cooking.
same diameter as the air exhaust outlet hole. If a pipe with   -  The non-regenerable active carbon filters must be replaced
a smaller diameter is used, the efficiency of the product may   at least every 4 months. The saturation of the active charcoal
be reduced and its operation may become noisier.  depends on the more or less prolonged use of the appliance,
on the type of kitchen and on the frequency with which anti-
•  If your appliance has been designed for use in habitations   grease filter is cleaned.
supplied with acentralised suction device perform the follow-  •  Before remounting the anti-grease filters and the regen-
ing operations:                      erable active charcoal filters it is important that they are
- The switch controls opening and closure of a valve using   completely dry.
a thermoelectical device. By placing the switch in the ON   •  Clean the hood frequently, both internally and exter-
position, after a minute, the valve opens rotating 90° allow-  nally, using a cloth dampened with denatured alcohol or
ing suction of the stale air. By placing the switch in the OFF   neutral liquid detergents that are non abrasive.
position, the valve closes after 100 seconds.  •  The lighting .system is designed for use during cooking
and not for the prolonged general lighting of the room. The
•  Installation:                     prolonged use of the lighting system significantly decreases
The following instruction should be followed to carry out the
- 5 -