Степлер SKIL 8200 LC F 0158200 LC. Инструкция на русском языке

TACKER
8200 (F0158200..)
ORIGINAL INSTRUCTIONS         6        ОРИГІНАЛЬНА ІНСТРУКЦІЯ
З ЕКСПЛУАТАЦІЇ              51
NOTICE ORIGINALE              8
????????? ??????? ??????    54
ORIGINALBETRIEBSANLEITUNG    11
INSTRUCTIUNI DE FOLOSIRE
ORIGINELE GEBRUIKSAANWIJZING  14         ORIGINALE                 58
BRUKSANVISNING I ORIGINAL    17        ОРИГИНАЛНО РЪКОВОДСТВО
60
ЗА ЕКСПЛОАТАЦИЯ
ORIGINAL BRUGSANVISNING      20
POVODNY NAVOD NA POUZITIE   64
ORIGINAL BRUKSANVISNING      22
ORIGINALNE UPUTE ZA RAD     67
ALKUPERAISET OHJEET          25
ORIGINALNO UPUTSTVO ZA RAD  69
MANUAL ORIGINAL              28
IZVIRNA NAVODILA            72
MANUAL ORIGINAL              31
ALGUPARANE KASUTUSJUHEND    74
ISTRUZIONI ORIGINALI         33
ORIGINALA LIETOSANAS PAMACIBA  77
EREDETI HASZNALATI UTASITAS  36
ORIGINALI INSTRUKCIJA       80
PUVODNIM NAVODEM K POUZIVANI  39
ИЗВОРНО УПАТСТВО ЗА РАБОТА  83
ORIJINAL ISLETME TALIMATI    42
UDHEZIMET ORIGJINALE        86
INSTRUKCJA ORYGINALNA        45
95
ПОДЛИННИК РУКОВОДСТВА
48
ПО ЭКСПЛУАТАЦИИ                                                    93
www.skil.com
SKIL Europe BV - Konijnenberg 60     10/14                           2610Z05734
4825 BD  Breda - The Netherlands

1     8200
???
?
???            16 mm
??? A?
??U????          Type 47
16 mm
Type 40       ???       ??     ??UAA?
2
3                        4                         5
2

c) Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
Tacker                          8200   d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
INTRODUCTION                             cord away from heat, oil, sharp edges or moving
•  This tool is intended for stapling and nailing of cardboard,   parts. Damaged or entangled cords increase the risk of
electric shock.
insulating material, fabrics, foils, leather and similar
materials on surfaces of wood or materials similar to   e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
wood
•  The tool is not suitable for the attachment of wall and   cord suitable for outdoor use reduces the risk of electric
shock.
ceiling panelling
•  This tool is not intended for professional use  f)  If operating a power tool in a damp location is
•  Read and save this instruction manual 3  unavoidable, use an earth leakage circuit breaker.
Use of an earth leakage circuit breaker reduces the risk
of electric shock.
TECHNICAL DATA 1
3) PERSONAL SAFETY
a) Stay alert, watch what you are doing and use
TOOL ELEMENTS 2                          common sense when operating a power tool. Do not
A  Lever for loading magazine            use a power tool while you are tired or under the
B  Slider                                influence of drugs, alcohol or medication. A moment
C  Magazine                              of inattention while operating power tools may result in
D  Tacker head                           serious personal injury.
E  On/off switch                       b) Use personal protective equipment. Always wear
F  Trigger switch                        eye protection. Protective equipment such as dust
G  Impact control selection wheel        mask, non-skid safety shoes, hard hat, or hearing
H  Reload indicator                      protection used for appropriate conditions will reduce
J  Ventilation slots                     personal injuries.
c) Prevent unintentional starting. Ensure the switch is
SAFETY                                   in the off-position before connecting to power
source and/or battery pack, picking up or carrying
GENERAL SAFETY INSTRUCTIONS              the tool. Carrying power tools with your finger on the
switch or energising power tools that have the switch on
invites accidents.
WARNING! Read all safety warnings and all   d) Remove any adjusting key or wrench before turning
instructions. Failure to follow the warnings and instructions
the power tool on. A wrench or a key left attached to a
may result in electric shock, fire and/or serious injury. Save   rotating part of the power tool may result in personal
all warnings and instructions for future reference. The
injury.
term “power tool” in the warnings refers to your mains-  e) Do not overreach. Keep proper footing and balance
operated (corded) power tool or battery-operated (cordless)
at all times. This enables better control of the power tool
power tool.                              in unexpected situations.
f)  Dress properly. Do not wear loose clothing or
1) WORK AREA SAFETY
jewelry. Keep your hair, clothing and gloves away
a) Keep work area clean and well lit. Cluttered or dark
from moving parts. Loose clothes, jewelry or long hair
areas invite accidents.
can be caught in moving parts.
b) Do not operate power tools in explosive
g) If devices are provided for the connection of dust
atmospheres, such as in the presence of flammable
extraction and collection facilities, ensure these are
liquids, gases or dust. Power tools create sparks which
connected and properly used. Use of dust collection
may ignite the dust or fumes.
can reduce dust-related hazards.
c) Keep children and bystanders away while operating
4) POWER TOOL USE AND CARE
a power tool. Distractions can cause you to lose control.
a) Do not force the power tool. Use the correct power
2) ELECTRICAL SAFETY
tool for your application. The correct power tool will do
a) Power tool plugs must match the outlet. Never
the job better and safer at the rate for which it was
modify the plug in any way. Do not use any adapter
designed.
plugs with earthed (grounded) power tools.
b) Do not use the power tool if the switch does not turn
Unmodified plugs and matching outlets will reduce risk of
it on and off. Any power tool that cannot be controlled
electric shock.
with the switch is dangerous and must be repaired.
b) Avoid body contact with earthed or grounded
c) Disconnect the plug from the power source and/or
surfaces such as pipes, radiators, ranges and
the battery pack from the power tool before making
refrigerators. There is an increased risk of electric
any adjustments, changing accessories, or storing
shock if your body is earthed or grounded.
power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
6