На сайте 124169 инструкций общим размером 502.7 Гб , которые состоят из 6277380 страниц
Руководство пользователя NOYAFA NF-905. Основные функции, характеристики и условия эксплуатации изложены на 4 страницах документа в pdf формате.
Доступно к просмотру 4 страницы. Рекомендуем вам скачать файл инструкции, поскольку онлайн просмотр документа может сильно отличаться от оригинала.
NF-905 NF-905-5mW/NF-905-10mW/NF-905-20mW/ NF-905-30mW/NF-905-50mW NOYAFA 905 FIBER MULFUNCTION
Device Outline Please read and study safety notice before use or maintain the device. Dust Cover ·Do not expose the device to direct sunlight. ·Please protect eyes preventing laser pointblank On/Off key from harming as laser emitter works. Rubber Bar Power Indicator ·It usually works against high temperature that result in contraction of laser emitter's life. LED 'Lighting' “Red Light”Testing Key key ·The laser emitter's interface should be maintained in clean status. ·The device's push-pull interface works against heavy force. ·Please put on dust cover in case there would be dust settled down in as stop using it. ·Please put out batteries as stop using. LED Lighting Lamp ST port FC port SC port
Brief Introduction: Feature: N F-905 series are of red lighting source upon 650 nm conductor 1.FC/SC/ST ports are changeable and available to connect for laser enitter, drived by constant current source to emit regular detector against light leak or poor contact,further to greatly red light. Connecting the interface in multi-mode or singal mode decrease possible radiation to user for safety. starts up fiber malfunction testing. 2.The light emitted at LD TRAP is taken on long reach and It is a indispensible tool in respects of fiber engineering, powerful spotlight. maintaining,producing and studying of light components . 3.Macro energy, Strong signal, Sufficient lighting, High accuracy. 4.LED lighting for working in darkness. 5.Simple buttons for convenient using. 6.Push-pull dust cover and rubber bar for comfortable holding. Useage: 1.Open battries cover,install in 1.5V batteries on correct positive and negative terminals, close batteries cover . ( Notice:do not reverse batteries) 2.Open dust cover,and pull out the rubber plug in FC port,turn on the power with power indicator lamp working.Then, press "Red Light" key to start up red light from port (Notice: Do not look directly at lighting port against hurting eyes.) 3.Press"Red Light" key once more to change into lighting impulse mode for constant flashing. (Impulse frewuency in range of 2– 3Hz or 9 Hz) 4.Press "Red Light" key again to turn off lighting source, (switch mode :Continuum-Impulse-Continuum). 5.Connecting fiber into port and pressing " Red Light " key to Fiber Malfunction Tester choose switch mode (Continuum or Impulse).