Видеомагнитофон SONY SLV-SE20UX. Инструкция на английском языке

3-865-365-12 (1)
Video Cassette
Recorder
Operating Instructions
PAL NTSC 4.43
SLV-SE20EX/UX
©1999 by Sony Corporation

WARNING                             Installing
• Allow adequate air circulation to prevent
To prevent fire or shock hazard, do not expose  internal heat buildup.
the unit to rain or moisture.       • Do not place the unit on surfaces (rugs,
To avoid electrical shock, do not open the  blankets, etc.) or near materials (curtains,
cabinet. Refer servicing to qualified personnel  draperies) that may block the ventilation
only.                                 slots.
• Do not install the unit near heat sources
Mains lead must only be changed at a qualified  such as radiators or air ducts, or in a place
service shop.                         subject to direct sunlight, excessive dust,
mechanical vibration or shock.
Notice for customers in the United  • Do not install the unit in an inclined
Kingdom and Republic of Ireland       position. It is designed to be operated in a
horizontal position only.
A moulded plug complying with BS1363 is  • Keep the unit and cassettes away from
fitted to this equipment for your safety and  equipment with strong magnets, such as
convenience.                          microwave ovens or large loudspeakers.
If the 13A fitted plug does not match the outlet  • Do not place heavy objects on the unit.
socket in your home, please refer to your  • If the unit is brought directly from a cold to
Appointed Sony Dealer for advice.     a warm location, moisture may condense
inside the VCR and cause damage to the
Should the fuse in the plug supplied need to be  video head and tape. When you first install
replaced, a 5 AMP fuse approved by ASTA or  the unit, or when you move it from a cold to
BSI to BS1362, (i.e., marked with 2 or @ mark)  a warm location, wait for about three hours
must be used.                         before operating the unit.
If the plug supplied with this equipment has a
detachable fuse cover, be sure to attach the fuse  Caution
cover after you change the fuse.  Never use the  Television programmes, films, video tapes and
plug without the fuse cover.  If you should lose  other materials may be copyrighted.
the fuse cover, please contact your nearest  Unauthorized recording of such material may
Sony service station.               be contrary to the provisions of the copyright
laws. Also, use of this recorder with cable
Precautions                         television transmission may require
authorization from the cable television
Safety                              transmitter and/or programme owner.
• This unit operates on 220 – 240 V AC, 50 Hz.
Check that the unit’s operating voltage is
identical with your local power supply.  Compatible colour systems
• If anything falls into the cabinet, unplug the  This VCR is designed to record using the PAL
unit and have it checked by qualified  colour system and play back using the PAL
personnel before operating it any further.  and NTSC 4.43 colour systems.  Recording of
• The unit is not disconnected from the mains  video sources based on other colour systems
as long as it is connected to the mains, even  cannot be guaranteed.
if the unit itself has been turned off.
• Unplug the unit from the wall outlet if you
do not intend to use it for an extended
period of time. To disconnect the cord, pull
it out by the plug, never by the cord.
2  Introduction

Table of contents
Getting Started
4 Step 1: Unpacking
5 Step 2: Setting up the remote commander
8 Step 3: Connecting the VCR
12 Step 4: Setting up the VCR with the Auto Set Up function
13 Step 5: Tuning your TV to the VCR                                   Getting Started
15 Selecting a language
16 Presetting channels
19 Changing/disabling programme positions
25 Setting the clock
29 Setting your personal code
Basic Operations                    Additional Information
31 Playing a tape                   61 Troubleshooting
34 Recording TV programmes          64 Specifications
39 Recording TV programmes using    65 Index to parts and controls
the VIDEO Plus+ system*         Back cover
44 Setting the timer manually           Index
Additional Operations
47 Playing/searching at various
speeds
49 Setting the recording duration
time
50 Checking/changing/cancelling
timer settings
52 Searching using the Smart Search
function
55 Adjusting the picture
57 Changing menu options
59 Editing with another VCR
* VIDEO Plus+ and PlusCode are trademarks applied for by Gemstar Development Corp. VIDEO
Plus+ system is manufactured under license from Gemstar Development Corporation.
Introduction  3