TV тюнер GIGABYTE GT-PTV-TAF-RH. Инструкция на русском языке

1
12QM-TVPCI01-1001R
TV Tuner Card
1-3
1-1
1-2
Installation of a TV Tuner Card
on your computer.
the computer case.
card into the PCI slot.
Prior to installation, please check if the motherboard has one open PCI slot.
chassis with screws, and then replace
Secure the TV card to the computer
Take the TV card out of the anti-static
bag, and carefully, firmly insert the TV
Connect the FM antenna, digital TV
the TV card. Connect the USB receiver
(Note 2)  for the remote control to a USB port
antenna and stereo sound cable (Note 1)  to
1-4
(Note 3)
(Note 1)
(Note 2)
TV card.
2
the driver and software with ease.
with better signal reception (Note 3) .
The hardware installation is then completed!
The accessories may vary depending on different models.
4.0 for the TV card.
Installation of Driver and Softwares
Please place the receiver at a location where remote control signals are available.
away from sheltering buildings as possible as you can for better signal reception.
Click "Driver" to install TV card driver.
Find a location in your house where can get the best reception. The digital TV signals are
transmitted via a ground-based transmitter. Please place the antenna near the window and
start the PowerCinema installation.) Then follow the on-screen instructions to install
Extend the FM antenna and digital TV antenna, and place them on a location
Now you can connect the computer to an electrical outlet and power on the computer.
the AUTORUN screen will appear. If the screen does not appear, you can run "D:
When you place the supplied Installation CD into the CD-ROM drive of your computer,
Click "Power Cinema 4.0" to install PowerCinema
"D:\Drv\Setup.exe" to start the Driver installation and run D:\PCinema\Setup.exe" to
Follow the instructions in the next section for driver and software installation for the
\TVCard.exe"(D stands for the CD-ROM drive) to display the screen. (You can run

1
1-2
1-1
1-3
USB
USB
FM
PCI
(
)
PCI
(
)
(
(
(
(
1-4
exe
)
)
)
2
FM
(
AUTORUN
)
D:\Drv\Setup.exe
PowerCinema
D:)
)
Driver
PowerCinema 4.0
AUTORUN
Power Cinema 4.0
(
D:\PCinema\Setup.
"D:\TVCard.exe"

Cliquez “driver” pour installer les pilotes requis.   Cliquez “Power Cinema 4.0” pour installer le   logiciel de votre carte TV.
signal de reception que possible  (note 3) .  Positionnez l'antenne FM et TV numerique  a votre guise afin d'obtenir le meilleur   L'installation hardware est a present terminee !  Vous pouvez a present brancher votre ordinateur a une source electrique et le mettre en  route. Suivez les instructions de la section suivante po
1-4        drivers.         Etape                             (Note 1)   (Note 2)   (Note 3)
Sortez la carte TV de son emballage  plastifie et enfoncez la soigneusement sur   un port PCI disponible.   Verrouillez la carte a votre boitier en  utilisant les vis et refermez votre chassis.   l'antenne   FM,  l'antenne  Connectez numerique et le cable son stereo  (note 1)  a la  carte TV. Connectez le rec
Carte TV Tuner   Etape  Installation de votre Carte TV Tuner  Avant installation, verifiez si votre carte mere propose un emplacement PCI de libre.   1-1   1-2   1-3