Универсальный пульт ДУ PHILIPS SRU5030. Инструкция на русском языке

SRU 5030/87
GB  Instructions for use   4
I  Instruzioni per l'uso 11
Instrucciones
E                  18
de manejo
P  Manual de utilizacao 25
GR  Od
 	
  32
Инструкции по
RU                  40
использованию
CZ  Navod k pouziti  48
PL  Instrukcja obslugi  55
Quick, Clean & Easy Setup
www.philips.com/urc

Instructions for use
Contents
1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2.  Installing the remote control  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
English
Inserting the batteries  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Testing the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5
Setting the remote control  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7
3.  Keys and functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-8
4.  Extra possibilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-9
Adjusting device selection (Mode keys). . . . . . . . . . . . . . . . . . . . . . . . . . 8-9
Adding a function to the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Restoring the original remote control settings  . . . . . . . . . . . . . . . . . . . . . 9
5.  Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
6.  Need help? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Code list of all brands / equipment  . . . . . . . . . . . . . . . . . . . . . . . . . . 62-78
Information to the Consumer  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80
1. Introduction
Congratulations on your purchase of the Philips SRU 5030 universal remote
control. After installing the remote control you can operate a maximum of
3 different devices with it:TV, DVD player/recorder and VCR.
You can find information about how to prepare this remote control for use in
the chapter ‘Installing the remote control’.
2. Installing the remote control
Inserting the batteries
1   Press the cover inwards and slide it in the
direction of the arrow.
2   Place two AAA type batteries into the battery
compartment, as shown.
3   Slide the cover back and click it firmly into
place.
Note: If the mode keys (TV, DVD and VCR) blink four times after every key press, the
remote control is indicating that its batteries are running low. Replace the old
batteries with two new AAA batteries.
Testing the remote control
The remote control has been programmed to operate most Philips devices.
Because the SRU 5030 may use different signals for each brand and even for
different models of the same brand, it is advisable to test whether your
device responds to the SRU 5030.The example below (TV) instructs you
how to do this.You can repeat the same steps for other devices (DVD
player/ recorder and VCR) which you want to operate using the SRU 5030.
Example of TV:
1   Turn your TV on manually or use the original remote control.
Tune to channel 1.
2   Press the TV key to select TV.
Press the key until it lights up.
–   If the key does not light up, check whether the
batteries are properly inserted
(see ‘Inserting the batteries’).
4

Instructions for use
3  Check whether all the keys are working.
For an overview of the keys and their             English
functions see ‘3. Keys and functions’.
–  If the TV responds as it should to all of the
key commands the SRU 5030 is ready for use.
•  If the device does not respond at all or not to all of the
key commands, follow the instructions under
‘Setting the remote control’, or for online setup go to:
www.philips.com/urc.
Setting the remote control
This is only necessary if your device does not respond to the SRU 5030.
If that is the case, the SRU 5030 does not recognize the brand and/or model
of your device and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.You can repeat the
same steps for other devices (DVD player/recorder and VCR) which you
want to operate using the SRU 5030.
You can set the remote control either automatically or manually.
Automatically setting the remote control
The remote control will now automatically search for the right code for your
device.
Example of TV:
1  Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU 5030 emits the ‘switch off TV’ signal for all models of TV that
are stored in the memory.
•  If the device is a DVD-player/recorder or video recorder, insert a disk or
tape and start playback.
2  Press the TV key to select TV.
Press the key until it lights up.
3  Then keep keys 1 and 3 on the SRU 5030
pressed simultaneously for three seconds,
until the TV key flashes twice and then
remains lit.
5