Медиаплеер POPCORN HOUR HBR-200. Инструкция на русском языке

Hard Drive Installation Guide For Popcorn Hour C-200
CVBS  AUDIO OUT
R  L
LNK           ACT
COAX
RoHS     IR  OPTICAL  USB 2.0  ETHERNET  S-VIDEO  Y COMPONENT VIDEO Pr
Pb
S/PDIF
Step 1                                                Step 2                                                Step 3                                                Step 4
What you need:                                        Remove the screw as shown, and slide open the top     Removing the existing HDD rack.                       Removing existing HDD rack from cage and replacing it with
1) Popcorn Hour C-200.                                cover of C-200.                                       1) Remove all 4 screws as shown.                      HBR-200*
2) HBR-200 HDD BD Combo Rack.                                                                               2) Remove SATA and Power Cable, please take note      1) Remove all screws that secure the HDD rack.
3) BDR-200 Slim BD Slot-in.                                                                                     of the cables as you will need it later.          2) Slide in the HBR-200 and replace all screws,
4) SATA & Power cable.                                                                                      3) Set aside the screws.                                  make sure its tight.
5) 3 screws.
6) Philip screw driver.                                                                                               Tip:  You may like to remove the cable clip               Note:  Please skip this step, if your Popcorn Hour
for easy access of the screws.                           C-200 comes pre-install with HBR-200.
Step 5                                                Step 6                                                Step 7                                                Step 8
Connect the SATA and Power cable as shown to the      Slide in the BDR-200 on top of HBR-200, make sure     Installing the BDR-200.                               Reverse the whole process in step 3 to fasten your new
BDR-200 prior sliding into the HBR-200.               that the SATA and power cable are properly extended   1) Ensure that the screw holes are align.             combo rack to your Popcorn Hour C-200.
towards the end.                                      2) Using the supplied screws, please secure the BDR-200
to the combo rack.
Tip:  Slide in the cable first, it will be easier!  3) Make sure the face plate is flash flat with the combo
rack at the front.
SATA
SATA2  SATA1
Step 9                                                Step 10                                               Step 11                                               Step 12
Setting aside the BDR-200 SATA and power cable,       Connecting power to the BDR-200.                      Connecting the SATA cable from your BDR-200 to your   Now your Popcorn Hour is truly a Hybrid Networked and
please reconnect the HDD rack SATA and power          1) The supplied power cable from BDR-200, it’s a female   Popcorn Hour C-200.                               Blu-Ray media player!
cable to your HBR-200 as shown.                           connector.                                        1) On your C-200 mainboard, locate the SATA connectors.
2) Your Popcorn Hour C-200 comes factory pre-fitted with   2) Remove SATA1 as shown (SATA2 connects to the HBR-200).  Congratulations on your purchase !
a extra male power cable.                         3) Replace it with the SATA cable from BDR-200.
3) Connect the both together, and make sure its secure as   4) Now it’s good time to organize the cables in your C-200 by
shown.                                                using the factory supplied clips.
Tip:  You may like to cut the cable tight to remove
the factory fitted SATA cable which is no longer
needed.