Сабвуфер YAMAHA YST-SW012. Инструкция на русском языке

G
YST-SW012
SUBWOOFER SYSTEM
ENCEINTE A CAISSON DE GRAVE
OWNER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
BRUKSANVISNING
MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES
GEBRUIKSAANWIJZING
i

Precautions: Read this before operating this unit
•To assure the finest performance, please read this manual   • Never open the cabinet. It might cause an electric shock
carefully. Keep it in a safe place for future reference.  since this unit uses a high voltage. It might also cause
• Install this unit in a cool, dry, clean place - away from   personal injury and/or damage to this unit.
windows, heat sources, sources of excessive vibration,   • When using a humidifier, be sure to avoid condensation
dust, moisture and cold. Avoid sources of humming   inside this unit by allowing enough spaces around this unit
(transformers, motors). To prevent fire or electrical   or avoiding excess humidification. Condensation might
shock, do not expose this unit to rain or water.  cause a fire, damage to this unit, and/or electric shock.
• Never open the cabinet. If any foreign objects drop into   • Super-bass frequencies reproduced by this unit may
the set, contact your dealer.                 cause a turntable to generate a howling sound. In such a
• The voltage to be used must be the same as that specified   case, move this unit away from the turntable.
on the rear panel. Using this unit with a higher voltage   • This unit may be damaged if certain sounds are
than specified is dangerous and may cause a fire and/or   continuously outputted at high volume level. For
electric shock.                               example, if 20 Hz-50 Hz sine waves from a test disc,
• To reduce the risk of fire or electric shock, do not expose   bass sounds from electronic instruments, etc. are
this unit to rain or moisture.                continuously outputted, or when the stylus of a
• Do not use force on switches, controls, or connection   turntable touches the surface of a disc, reduce the
wires. When moving the unit, first disconnect the power   volume level to prevent this unit from being damaged.
plug and the wires connected to other equipments.   • If you hear distorted noise (i.e., unnatural, intermittent
Never pull the wires themselves.              “rapping” or “hammering” sounds) coming from this
• When not planning to use this unit for a long period (i.e.,   unit, reduce the volume level. Extremely loud playing
vacation, etc.), disconnect the AC power plug from the   of a movie soundtrack’s low frequency, bass-heavy
wall outlet.                                  sounds or similarly loud popular music passages can
• Since this unit has a built-in power amplifier, heat will   damage this subwoofer system.
radiate from the rear panel. Place the unit apart from the   • Vibration generated by super-bass frequencies may
walls, allowing at least 20 cm of space above, behind and   distort images on a TV. In such a case, move this unit
on both sides of the unit to prevent fire or damage.   away from the TV set.
Furthermore, do not position with the rear panel facing   • Do not attempt to clean this unit with chemical solvents
down on the floor or other surfaces.          as this might damage the finish. Use a clean, dry cloth.
• Do not cover the rear panel of this unit with a newspaper,   • Be sure to read the “TROUBLESHOOTING” section
a tablecloth, a curtain, etc. in order not to obstruct heat   regarding common operating errors before concluding
radiation. If the temperature inside the unit rises, it may   that the unit is faulty.
cause fire, damage to the unit and/or personal injury.   • Install this unit near the wall outlet and where the AC
• Do not place the following objects on this unit:  power plug can be reached easily.
Glass, china, small metallic etc.           • Secure placement or installation is the owner’s
If glass etc. falls by vibrations and breaks, it may   responsibility. YAMAHA shall not be liable for any
cause bodily injury.                        accident caused by improper placement or
A burning candle etc.                         installation of the subwoofer.
If the candle falls by vibrations, it may cause fire and
bodily injury.
WARNING
A vessel with water in it                    TO REDUCE THE RISK OF FIRE OR ELECTRIC
If the vessel falls by vibrations and water spills, it   SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN
may cause damage to the speaker, and/or you may get   OR MOISTURE.
an electric shock.
• Do not place this unit where foreign objects such as
water drips might fall. It might cause a fire, damage to   As long as this unit is connected to the AC wall out-
this unit, and/or personal injury.           let, it is not disconnected from the AC power source
even if you turn off this unit by POWER.
• Never put a hand or a foreign object into the YST port
located on the right side of this unit. When moving this
unit, do not hold the port as it might cause personal
injury and/or damage to this unit.           This unit features a magnetically shielded design, but
• Never place a fragile object near the YST port of this   there is still a chance that placing it too close to a TV
unit. If the object falls or drops by the air pressure, it may   set might impair picture color. Should this happen,
cause damage to the unit and/or personal injury.  move this unit away from the TV set.
i

For U.K. customers                                                                        English
If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an
appropriate 3 pin plug fitted. For details, refer to the following instructions.
Note: The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is hazardous if
engaged in a live socket outlet.
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT:
THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to
the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be
connected to the terminal which is marked with the letter L or coloured RED. Making sure that neither core is
connected to the earth terminal of the three pin plug.
• VOLTAGE SELECTOR
(For China, Korea, Asia and General models)
The voltage selector switch on the rear panel of this unit must be set for your local main voltage BEFORE plugging
this unit into the AC main supply. Voltages are 110–120/220–240 V AC, 50/60 Hz.
Table of contents
Precautions: Read this before operating this unit  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  2
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Supplied accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Positioning the subwoofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  2
Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  3
Basic connection example . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Connecting components and the subwoofer to AC power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Using the subwoofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  4
Pre-adjusting the subwoofer volume . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Advanced Yamaha Active Servo Technology II  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  6
Specifications  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  7
Frequency response. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
1