Акустика YAMAHA NS-P9900. Инструкция на русском языке

GT
NS-P9900                             SPEAKER SYSTEM             English
OWNER’S MANUAL
Thank you for selecting this Yamaha product.
This speaker package consists of the component shown on the table below.
NS-C9900       Center speaker                    x 1
NS-P9900
NS-E9900       Surround speaker                  x 2
PRECAUTIONS                                              Русский
Read this before using the speakers.
• To assure the finest performance, please read this manual   • Do not place the speaker where it is liable to be knocked
carefully. Keep it in a safe place for future reference.  over or struck by falling objects. Stable placement will also
• Install the speaker in a cool, dry, clean place – away from   ensure better sound performance.
windows, heat sources, sources of excessive vibration,   • Placing the speaker on the same shelf or rack as the   Polski
dust, moisture and cold.                       turntable can result in feedback.
• Avoid sources of humming (transformers, motors). To   • When moving the speaker, do not hold the port as it might
prevent fire or electrical shock, do not expose the speaker   cause personal injury and/or damage to the speaker.
to rain or water.                            • Any time you note distortion, reduce the volume control on
• To prevent the enclosure from warping or discoloring, do not   your amplifier to a lower setting. Never allow your amplifier
place the speaker where it will be exposed to direct sunlight   to be driven into “clipping”. Otherwise the speaker may be
or excessive humidity.                         damaged.
• Do not place the following objects on the speakers:  • When using an amplifier with a rated output power higher
Glass, china, etc.                             than the nominal input power of the speaker, care should be
If glass etc. falls by vibrations and breaks, it may cause   taken never to exceed the speaker’s maximum input.
personal injury.                           • Do not attempt to clean the speaker with chemical solvents
A burning candle etc.                          as this might damage the finish. Use a clean, dry cloth.
If the candle falls by vibrations, it may cause fire and
• Do not attempt to modify or fix the speaker. Contact
personal injury.
qualified Yamaha service personnel when any service is
A vessel with water in it
needed. The cabinet should never be opened for any
If the vessel falls by vibrations and water spills, it may
reasons.
cause damage to the speaker, and/or you may get an
• Secure placement or installation is the owner’s
electric shock.
responsibility. Yamaha shall not be liable for any
• Do not place the speaker where foreign objects such as
accident caused by improper placement or installation
water drips might fall. It might cause a fire, damage to the
of the speaker.
speaker, and/or personal injury.
SUPPLIED ACCESSORIES
NS-C9900                                     NS-E9900
Pad x 4        Bind screw    Fastener (small)
(M4, 10 mm) x 4      x 4
Speaker cable    Fastener x 4
(4 m) x 1
Speaker cable              Bracket
(10 m) x 2                  x 2
1 En

PLACING THE SPEAKERS
Speaker layout image
NS-C9900 (Center speaker)
Place this unit precisely between the front speakers.
Front
NS-E9900 (Surround speaker)
Subwoofer             Place these units behind your listening position.
NS-C9900
NS-E9900
¦ Setting up the speaker (NS-C9900)
Place the speaker above a TV or inside of the TV rack
so that the speaker and the TV are aligned vertically.  Securing this unit
Peel off the film from each of the four supplied fasteners
Notes
and then secure them to the bottom four corners of this
• Do not place the speaker on top of the TV whose area is
unit or the top of the rack, etc.
smaller than the bottom area of the speaker. If placed,
the speaker may fall and cause injury.
• Do not place the speaker on top of the TV with an
inclination.
• This speaker features a magnetically shielded design,   Fastener
but there is still a chance that placing it too close to a
TV set might impair picture color or create a buzzing
noise. Should this happen, move the speaker away                              Peal off
from the TV set.                                                              the film.
• Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive
strength is weakened if the surface is dirty, oily
or wet and that this may cause the center
speaker to drop.
• Do not touch the adhesive surface after peeling
off the film as this will weaken its adhesive
strength.
2 En

¦ Setting up the speakers (NS-E9900)          4 Hang the speaker by mounting the holes on the
Mount the speakers on a wall or place the speakers on   protruding screws.
a shelf. Determine the best position by following the   Make that the screws are securely affixed by the   English
owner’s manual supplied with your amplifier.     narrow parts of the holes.
Mounting the speakers on the wall
1 Fasten the supplied bracket on the rear panel with
screws.
Holes
Caution
• Each speaker weighs 4.9 kg.
• Do not mount the speakers on thin plywood or a wall
composed of a soft surface material. If mounted, the
2 Attach the supplied pads in the following indicated   screws may pull out of the flimsy surface and the
positions.                                   speakers may fall. This may damage the speakers or
cause personal injury.
Pads                   • Do not affix the speakers to a wall using nails,
adhesives, or any other unstable hardware. Long-term
Approx. 10 mm         Approx. 10 mm
use and vibrations may cause the speakers to fall.
• To avoid accidents resulting from tripping over loose
speaker cables, fix the cables to the wall.
• Select an appropriate position on the wall to mount the
speaker so that no one will injure his/her head or face.
Approx.
60 mm
You can also use the screw holes on the bottom of the
Rear panel                 NS-E9900 for installing the speakers on commercially
available speaker stands (if you do not use the provided
3 Fasten two screws into a firm wall or wall support at   brackets).
the interval shown below.                                     Bottom view
Tapping screw (?3.5–4 mm)
(Available at the hardware
store)
60 mm
Min.
20 mm
3 mm
* Before installing, please refer to the instruction manual
of the speaker stand.
40 mm
Wall/Wall
support
3 En