CD плеер SONY CDP-XE200. Инструкция на русском языке

3-810-322-71 (1)
Operating Instructions                                                       EN
Instrukcja obslugi                                                           PL
##########                                                                   RF
CDP-XE500
CDP-XE300
CDP-XE200
a 1995 by Sony Corporation

On adjusting volume
WARNING                        Precautions                     • Do not turn up the volume while
listening to a portion with very low
To prevent fire or shock                                          level inputs or no audio signals. If you
On safety                         do, the speakers may be damaged
hazard, do not expose the unit
• Caution — The use of optical    when a peak level portion is played.
to rain or moisture.              instruments with this product will
To avoid electrical shock, do     increase eye hazard.
not open the cabinet. Refer     • Should any solid object or liquid fall  On cleaning
into the cabinet, unplug the player and  • Clean the cabinet, panel and controls
servicing to qualified                                            with a soft cloth slightly moistened
have it checked by qualified personnel
personnel only.                   before operating it any further.  with a mild detergent solution. Do not
use any type of abrasive pad, scouring
The laser component in this product                              powder or solvent such as alcohol or
On power sources
is capable of emitting radiation                                 benzine.
• Before operating the player, check that
exceeding the limit for Class 1.
the operating voltage of the player is
If you have any questions or
identical with your local power
problems concerning your player,
supply. The operating voltage is
please consult your nearest Sony
indicated on the nameplate at the rear
dealer.
of the player.
• The player is not disconnected from
the AC power source (mains) as long
as it is connected to the wall outlet,
even if the player itself has been  Welcome!
This appliance is classified as a CLASS 1  turned off.
LASER product. The CLASS 1 LASER  • If you are not going to use the player  Thank you for purchasing the Sony
PRODUCT MARKING is located on the  for a long time, be sure to disconnect  Compact Disc Player. Before operating
rear exterior.                    the player from the wall outlet. To  the unit, please read this manual
disconnect the AC power cord (mains  thoroughly and retain it for future
The following caution label is located  lead), grasp the plug itself;  never pull  reference.
inside of the unit.
the cord.
• AC power cord must be changed only
at the qualified service shop.
About This Manual
On placement
• Place the player in a location with  The instructions in this manual are for
adequate ventilation to prevent heat  models CDP-XE500, CDP-XE300 and
build-up in the player.       CDP-XE200. The CDP-XE500 is the
• Do not place the player on a soft  model used for illustration purposes.
surface such as a rug that might block  Any difference in operation is clearly
the ventilation holes on the bottom.  indicated in the text, for example, “CDP-
• Do not place the player in a location  XE500 only.”
near heat sources, or in a place subject
Conventions
to direct sunlight, excessive dust or
• Instructions in this manual describe
mechanical shock.
the controls on the player.
You can also use the controls on the
On operation                      remote if they have the same or
• If the player is brought directly from a  similar names as those on the player.
cold to a warm location, or is placed in  In the instructions, the buttons on the
a very damp room, moisture may  remote are indicated in parentheses.
condense on the lenses inside the  • The following icons are used in this
player. Should this occur, the player  manual:
may not operate properly. In this case,
remove the disc and leave the player  Indicates that you can do the
turned on for about an hour until the  task using the remote.
moisture evaporates.                  (Note that the CDP-XE200
cannot do the tasks marked
with this icon.)
Indicates hints and tips for
making the task easier.
2 EN

Getting Started
TABLE OF CONTENTS
Getting Started
Unpacking ........................................................................................................ 4
Hooking Up the System ................................................................................. 4
Playing a CD ........................................................................................................ 6
Playing CDs
Using the Display ........................................................................................... 7
Locating a Specific Track or a Particular Point in a Track ........................ 8
Playing Tracks Repeatedly ............................................................................ 8
Playing in Random Order (Shuffle Play) .................................................... 9
Creating Your Own Program (Program Play) ............................................ 9
EN
Recording From CDs
Recording Your Own Program ................................................................... 11
Recording a CD by Specifying Tape Length (Time Edit)........................ 12
Fading In or Out............................................................................................ 13
Adjusting the Recording Level (Peak Search) .......................................... 14
Additional Information
Notes on CDs................................................................................................. 14
Troubleshooting ............................................................................................ 15
Specifications ................................................................................................. 15
Index
Index ............................................................................................................... 16
3 EN