Устройство ROTEL RX975. Инструкция на английском языке

Owner’s Manual
RX-975
AM/FM Stereo Receiver

RX-975 AM/FM Stereo Receiver                                    2
WARNING:                           Connect the component to the power outlet only with the sup-  NOTE TO CATV SYSTEM INSTALLER:
plied power supply cable or an exact equivalent. Do not modify
There are no user serviceable parts inside. Refer all                 Call the CATV system or antenna installer’s attention to Ar-
servicing to qualified service personnel.  the supplied cable in any way. Do not attempt to defeat ground-  ticle 820-40 of the NEC. This provides guidelines for proper
ing and/or polarization provisions. Do not use extension cords.
WARNING:                                                              grounding and, in particular, specifies that the cable ground
Do not route the power cord where it will be crushed, pinched,  shall be connected to the grounding system of the building,
To reduce the risk of fire or electric shock, do not  bent at severe angles, exposed to heat, or damaged in any  as close to the pint of cable entry as practical. See installa-
expose the unit to moisture or water. Do not allow  way. Pay particular attention to the power cord at the plug  tion diagram.
foreign objects to get into the enclosure. If the unit  and where it exits the back of the unit.
is exposed to moisture, or a foreign object gets into                 NOTE:
the enclosure, immediately disconnect the power cord  The power cord should be unplugged from the wall outlet if  This equipment has been tested and found to comply with the
from the wall. Take the unit to a qualified service  the unit is to be left unused for a long period of time.  limits for a Class B digital device, pursuant to Part 15 of the
person for inspection and necessary repairs.  Immediately stop using the component and have it inspected  FCC Rules. These limits are designed to provide reasonable
and/or serviced by a qualified service agency if:  protection against interference in a residential installation.
Read all the instructions before connecting or operating the
component. Keep this manual so you can refer to these safety  • The power supply cord or plug has been damaged.  This equipment generates and can radiate radio frequency
instructions.                                                         energy and, if not installed and used in accordance with the
• Objects have fallen or liquid has been spilled into the unit.  instructions, may cause interference to radio or TV commu-
Heed all warnings and safety information in these instruc-  • The unit has been exposed to rain.  nications. There is no guarantee that interference will not occur
tions and on the product itself. Follow all operating instruc-        in a particular installation. If this equipment does cause in-
tions.                             • The unit shows signs of improper operation  terference to radio or television reception, which can deter-
Clean the enclosure only with a dry cloth or a vacuum cleaner.  • The unit has been dropped or damaged in any way  mined by turning the equipment off and on, try to correct
the interference by one or more of the following measures:
You must allow 10 cm or 4 inches of unobstructed clearance  Place the unit on a fixed, level surface strong enough to sup-
around the unit. Do not place the unit on a bed, sofa, rug, or  port its weight. Do not place it on a moveable cart that could  • Reorient or relocate the receiving antenna.
similar surface that could block the ventilation slots. If the  tip over.  • Increase the separation between the unit and the televi-
component is placed in a bookcase or cabinet, there must be             sion tuner.
ventilation of the cabinet to allow proper cooling.
• Connect the unit to an AC power outlet on a different elec-
Keep the component away from radiators, heat registers, stoves,         trical circuit.
or any other appliance that produces heat.
• Consult your authorized Rotel retailer for assistance.
The unit must be connected to a power supply only of the type
and voltage specified on the rear panel of the unit.

3                                                         English
Figure 1: Controls and Connections