Устройство ROTEL RSX1055. Инструкция на английском языке

Owner’s Manual
RSX-1055
Surround Sound Receiver
SURROUND SOUND RECEIVER  RSX-1055
POWER
VOLUME
1  2  3  4  5  TUNING  BAND  CD  TUNER  TAPE  VIDEO1  VIDEO2  VIDEO3  VIDEO4  VIDEO5
DOLBY  DTS  MULTI  DYNAMIC
6  7  8  9  0  DIRECT  MONO  MEMORY  2CH  PLII/3ST  NEO 6  DSP  INPUT  RANGE  ZONE  REC

Notice
The COMPUTER I/O connection should be handled by authorized person
only.
FCC Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instruction, may cause harmful interference to radio communica-
tions.
However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.(TV, radio, etc.)
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for additional
help.
Caution
This device complies with part 15 of the FCC Rules operation is subject to
the following to conditions:  (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.

Important Safety Instructions                         NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna
installer’s attention to Article 820-40 of the NEC. This provides guidelines
for proper grounding and, in particular, specifies that the cable ground
WARNING: There are no user serviceable parts inside. Refer  shall be connected to the grounding system of the building, as close to the
all servicing to qualified service personnel.         point of cable entry as practical. See installation diagram.
WARNING: To reduce the risk of fire or electric shock, do not  NOTE: This equipment has been tested and found to comply with the lim-
expose the unit to moisture or water. Do not allow foreign  its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
objects to get into the enclosure. If the unit is exposed to moisture,  limits are designed to provide reasonable protection against interference
or a foreign object gets into the enclosure, immediately dis-  in a residential installation. This equipment generates and can radiate ra-
connect the power cord from the wall. Take the unit to a qualified  dio frequency energy and, if not installed and used in accordance with
service person for inspection and necessary repairs.  the instructions, may cause interference to radio or TV communications.
There is no guarantee that interference will not occur in a particular instal-
Read all the instructions before connecting or operating the component.
Keep this manual so you can refer to these safety instructions.  lation. If this equipment does cause interference to radio or television re-
ception, which can be determined by turning the equipment off and on,
Heed all warnings and safety information in these instructions and on the  try to correct the interference by one or more of the following measures:
product itself. Follow all operating instructions.
• Reorient or relocate the receiving antenna.
Clean the enclosure only with a dry cloth or a vacuum cleaner.
• Increase the separation between the unit and the television tuner.
You must allow 10 cm or 4 inches of unobstructed clearance around the
unit. Do not place the unit on a bed, sofa, rug, or similar surface that could  • Connect the unit to an AC power outlet on a different electrical circuit.
block the ventilation openings. If the unit is placed in a bookcase or cabi-  • Consult your authorized Rotel retailer for assistance.
net, there must be ventilation of the cabinet to allow proper cooling.
Keep the component away from radiators, heat registers, stoves, or any
other appliance that produces heat.
The unit must be connected to a power supply only of the type and voltage
specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz)
Connect the component to the power outlet only with the supplied power
supply cable or an exact equivalent. Do not modify the supplied cable. Do
not defeat grounding and/or polarization provisions. The cable should be
connected to a 2-pin polarized wall outlet, matching the wide blade of the
plug to the wide slot of the receptacle. Do not use extension cords.
Do not route the power cord where it will be crushed, pinched, bent, ex-
posed to heat, or damaged in any way. Pay particular attention to the power
cord at the plug and where it exits the back of the unit.
The power cord should be unplugged from the wall outlet if the unit is to be
left unused for a long period of time.
Immediately stop using the component and have it inspected and/or ser-
viced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way