Ресивер PIONEER VSX-820. Инструкция на русском языке

VSX-820_SYXCN_En.book  1 ???  2010?4?12? ??? ??6?52?
VSX-820-S/-K
Discover the benefits of registering your product online at
http://www.pioneer.co.uk (or http://www.pioneer.eu).
Decouvrez les nombreux avantages offerts en enregistrant votre produit en ligne
maintenant sur http://www.pioneer.fr (ou http://www.pioneer.eu).
Зарегистрируйте Baшe изделие на http://www.pioneer-rus.ru (или
http://www.pioneer.eu). Oзнакомьтесь с преимуществами регистрации в Интернет
Operating Instructions
Mode d’emploi
Инструкции по эксплуатации

VSX-820_SYXCN_En.book  2 ???  2010?4?12? ??? ??6?52?
IMPORTANT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol,   CAUTION:  The exclamation point within an equilateral
within an equilateral triangle, is intended to  TO PREVENT THE RISK OF ELECTRIC   triangle is intended to alert the user to the
alert the user to the presence of uninsulated  SHOCK, DO NOT REMOVE COVER (OR   presence of important operating and
“dangerous voltage” within the product’s   BACK). NO USER-SERVICEABLE PARTS  maintenance (servicing) instructions in the
enclosure that may be of sufficient  INSIDE. REFER SERVICING TO QUALIFIED  literature accompanying the appliance.
magnitude to constitute a risk of electric   SERVICE PERSONNEL.
shock to persons.
D3-4-2-1-1_A1_En
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified
service personnel.
IMPORTANT: THE MOULDED PLUG
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 10 amp fuse is fitted in this plug. Should
the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark  or the BSI mark  on the body of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.
If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of
safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Blue : Neutral    Brown : Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows;
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured RED.
How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.
D3-4-2-1-2-2*_A1_En
WARNING                               VENTILATION CAUTION
This equipment is not waterproof. To prevent a fire or  When installing this unit, make sure to leave space
shock hazard, do not place any container filled with  around the unit for ventilation to improve heat radiation
liquid near this equipment (such as a vase or flower   (at least 40 cm at top, 10 cm at rear, and 20 cm at each
pot) or expose it to dripping, splashing, rain or  side).
moisture.
D3-4-2-1-3_A1_En  WARNING
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the product,
WARNING                               and to protect it from overheating. To prevent fire
Before plugging in for the first time, read the following
hazard, the openings should never be blocked or
section carefully.                    covered with items (such as newspapers, table-cloths,
The voltage of the available power supply differs  curtains) or by operating the equipment on thick carpet
according to country or region. Be sure that the   or a bed.
power supply voltage of the area where this unit
D3-4-2-1-7b*_A1_En
will be used meets the required voltage (e.g., 230 V
or 120 V) written on the rear panel.
D3-4-2-1-4*_A1_En
WARNING
To prevent a fire hazard, do not place any naked flame
sources (such as a lighted candle) on the equipment.
D3-4-2-1-7a_A1_En

VSX-820_SYXCN_En.book  3 ???  2010?4?12? ??? ??6?52?
Information for users on collection and disposal of old equipment and used batteries
Symbol for   These symbols on the products, packaging, and/or accompanying documents mean
equipment   that used electrical and electronic products and batteries should not be mixed with
general household waste.
For proper treatment, recovery and recycling of old products and used batteries,
please take them to applicable collection points in accordance with your national
legislation.
By disposing of these products and batteries correctly, you will help to save valuable
Symbol examples  resources and prevent any potential negative effects on human health and the
for batteries  environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries,
please contact your local municipality, your waste disposal service or the point of sale
where you purchased the items.
These symbols are only valid in the European Union.
For countries outside the European Union:
If you wish to discard these items, please contact your local authorities or dealer and
ask for the correct method of disposal.
Pb
K058a_A1_En
Operating Environment                 This product is for general household purposes. Any
Operating environment temperature and humidity:  failure due to use for other than household purposes
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH   (such as long-term use for business purposes in a
(cooling vents not blocked)           restaurant or use in a car or ship) and which requires
Do not install this unit in a poorly ventilated area, or in  repair will be charged for even during the warranty
locations exposed to high humidity or direct sunlight (or   period.
strong artificial light)
K041_A1_En
D3-4-2-1-7c*_A1_En
If the AC plug of this unit does not match the AC  Manufactured under license from Dolby
outlet you want to use, the plug must be removed   Laboratories. Dolby, Pro Logic, Surround EX
and appropriate one fitted. Replacement and   and the double-D symbol are trademarks of
mounting of an AC plug on the power supply cord of  Dolby Laboratories.
this unit should be performed only by qualified
service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make
sure it is properly disposed of after removal.  Manufactured under license under U.S.
The equipment should be disconnected by removing   Patent #’s: 5,451,942; 5,956,674; 5,974,380;
the mains plug from the wall socket when left unused  5,978,762; 6,226,616; 6,487,535; 7,212,872;
for a long period of time (for example, when on   7,333,929; 7,392,195; 7,272,567 & other U.S.
vacation).
D3-4-2-2-1a_A1_En  and worldwide patents issued & pending.
DTS and the Symbol are registered
trademarks, & DTS-HD, DTS-HD Master
CAUTION                               Audio, and the DTS logos are trademarks of
The    STANDBY/ON switch on this unit will not  DTS, Inc. Product includes software. © DTS,
completely shut off all power from the AC outlet.  Inc. All Rights Reserved.
Since the power cord serves as the main disconnect
device for the unit, you will need to unplug it from the
AC outlet to shut down all power. Therefore, make
sure the unit has been installed so that the power
cord can be easily unplugged from the AC outlet in
case of an accident. To avoid fire hazard, the power
cord should also be unplugged from the AC outlet
when left unused for a long period of time (for
example, when on vacation).
D3-4-2-2-2a*_A1_En