Аудиосистема PIONEER S-CN301. Инструкция на русском языке

S-CN301-LR.book  1 ???  2012?2?10? ??? ??4?37?
S-CN301-LR
?????
(Etats-Unis)
??Кь
1
En

S-CN301-LR.book  2 ???  2012?2?10? ??? ??4?37?
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the
instructions, put them away in a safe place for future reference.
Temperature:         15 ?C to 25 ?C (59 ?F to 77 ?F)
Before you start                                        Relative Humidity: 35 % to 65 % (winter)
• The nominal impedance of this speaker system is 6 ?.               40 % to 70 % (summer)
Connect the speaker system to an amplifier with a load   •  When using room air-conditioners or stoves to rapidly cool
impedance ranging 6 ? (a model with “6 ?” displayed on the   or heat room spaces, take precautions to avoid excessive
speaker output terminals).                              dehumidification.
In order to prevent damage to the speaker system resulting from   •  Avoid placing the speaker near areas such as windows, as
input overload, please observe the following precautions:  outside air can cause condensation to occur within the
• Do not supply power to the speaker system in excess of the   speaker.
maximum permissible input.
Caution: in use
• When using a graphic equalizer to emphasize loud sounds in
the high-frequency range, do not use excessive amplifier   • Do not use the speaker to output distorted sound for long
volume.                                               periods of times. This can result in a fire hazard.
• Do not try to force a low-powered amplifier to produce loud   • Do not sit or stand on the speaker, or let children play on the
volumes of sound (the amplifier’s harmonic distortion will be   speaker.
increased, and you may damage the speaker).          • Do not put large or heavy objects on top of the speaker.
• The speaker has a built-in auto recovery circuit breaker that
Caution: installation                                  protects it from signal overloads. If the speaker is muted due
• Switch off and unplug your AV equipment and consult the   to an excessive signal input, turn down amplifier volume and
instructions when connecting up components. Make sure you   wait a few seconds. The circuit breaker will automatically
use the correct connecting cables.                    switch off and turn the speakers back on.
• Do not install the speaker system in areas exposed to direct
sunlight nor near heating appliances. Such conditions may   Cleaning the speaker cabinet
result in shrinkage of the wood materials and finish, leading to   With normal use, wiping with a dry cloth should be sufficient to
deformation of the enclosure, discoloration, or damage to the   keep the cabinet clean. If necessary, clean with a cloth dipped in
speakers.
a neutral cleanser diluted five or six times with water, and wrung
Conditions considered unpleasant by humans are     out well. Do not use furniture wax or cleansers.
detrimental to speakers as well. Providing a comfortable   Never use thinners, benzine, insecticide sprays or other chemicals
environment for the speakers will assist them in   on or near this unit since these will corrode the surfaces.
demonstrating their best performance. Please maintain the
usage environment as follows:
For U.S. model
WARNING: Handling the cord on this product or
cords associated with accessories sold with the
product may expose you to chemicals listed on
proposition 65 known to the State of California and
other governmental entities to cause cancer and
birth defect or other reproductive harm.
D36-P5_B1_En
For European model
If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used
electronic products in accordance with legislation that requires proper treatment, recovery and recycling.
Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to
designated collection facilities or to a retailer (if you purchase a similar new one).
For countries not mentioned above, please contact your local authorities for the correct method of disposal.
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential
negative effects on the environment and human health.
K058b_A1_En
2
En

S-CN301-LR.book  3 ???  2012?2?10? ??? ??4?37?
Mounting the Safety support fixture
How to install                                         • Make sure that the wall you intend to mount the speakers on
is strong enough to support them.
• Pass a commercially-available strong cord through the safety
Choosing where to place the speaker systems              support fixture to securely support the speaker to the wall. Be
sure that the wall to which you fasten the speaker is strong
enough to support the weight of the speaker. After fastening
the speaker, make sure that it does not fall over.
50 cm              20 cm                              • Do not attach the safety support fixture directly to the wall. It   English
11
(19  / 16  in.)      7                                  should only be used in conjunction with strong cord to prevent
from the side      (7  / 8  in.)                        the speaker from falling.
wall               from the
back wall     50? to 60?
• Do not install your speakers overhead on the ceiling or wall.
The grill is designed to be detachable, and as such it may fall
and cause damage or personal injury if installed overhead.
• Using the accessory screws, fasten the safety support fixtures
to the holes in the bottom of the speakers.
• Sounds played through speaker systems are easily affected in
subtle ways by the conditions in the listening space.
• For best sound, choose a solid floor upon which to place the
speakers, and position the speakers as illustrated above. The
level of low sounds can be adjusted by moving the speakers   Examples of mounting the speaker system using the
closer to or further from the back wall. Adjust the speakers so   safety support fixture
that they are equidistant from their respective side walls to
assure balanced sound.                                Mounting on the wall
• Place the left and right speakers equal distances from your   Grille  Safety support fixture
listening position for good stereo sound. Use speaker cords of
the same length for each speaker.
• If the room has a lot of reverberation, we recommend hanging
heavy fabric on the walls, and/or putting a carpet on the floor
to damp the sound. For best results, cover walls completely.
Screw
Speaker’s rear view  Strong cords
• Do not place the speaker on an unstable surface. It could
present a hazard if it falls, as well as damaging the equipment.  Mounting on the ceiling
• These speakers are bookshelf-type speakers which will give
their best performance when placed on a solid, level surface            Speaker’s rear view
off the floor. Placing the speakers directly on the floor will
Safety support fixture
result in boomy, undefined sound. Ideally, the tweeters should
Grille
be at about ear level when seated in your listening position.
• This unit has two screw holes on the
bottom panel. These holes are   Use M5 screws.
The screw hole depth:
meant for joint use with speaker
3
9 mm ( / 8  in.)                                             Screw
brackets and speaker stands;
speaker brackets are commercially                   Strong cords
available and can be used to mount
the speakers on a wall or ceiling. The                             Strong cords
diagram on the right shows the         3            • Loosen the screw on the grille’s back once, then bind the
60 mm (2  / 8  in.)
spacing and size of the holes. When                   strong cord around the screw several times and tighten the
choosing a speaker bracket, make                      screw.
sure that it can hold at least 2.9 kg (6            • Pass two strong cords through the safety support fixture, and
lbs 6 oz.). Please read through the                   fasten the speaker to the wall or ceiling as shown above.
safety cautions on this operating
instruction, also the instructions                  • If you mount the speakers on the wall or ceiling, first make
that come with the bracket. Speakers that are not mounted   sure that the mounting surface can bear at least 2.9 kg (6 lbs
properly are a hazard.                                6 oz.). If you’re unsure of the load capability, please seek
professional advice.
• When installing the speaker on the ceiling, the speaker will be
upside down. Even so, putting the grille in the proper way (the
way you can read Pioneer logo in the right way) is
recommended.
• After installing, make sure the speakers are securely fixed.
3
En