Радиоприемник HYUNDAI H-1549

H-1549
RADIO WITH ALARM                        РАДИОПРИЕМНИК
С БУДИЛЬНИКОМ
Instruction manual          Руководство по эксплуатации

Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
Front panel                                       Right panel
1  2  3  4  5  6  7 8  9 10
11
12
1. BAND button
2. TEMP/   button
3. Y-M-D/   button
4. AL.1 button
5. SNOOZE/SLEEP button
6. AL.2 button                        Utilization of the product
7. AL.SET button
8. MODE button
9.   button                           If you want to dispose this product, do not
10. Display                         mix it with general household waste. There is a
11. VOLUME regulator                separate collection system for used electronic
12. TUNE regulator                  products in accordance with legislation that
requires proper treatment, recovery and
Not indicated: power cord (back panel), FM   recycling.
antenna (back panel), temperature sensor   Please contact your local authorities for
(back panel), infrared sensor (top panel), line   the correct method of disposal. By doing so,
input (top panel), battery compartment   you will ensure that your disposed product
(bottom), DIMMER switch (top panel), RESET   undergoes the necessary treatment, recovery
button hole (back panel), LIGHT ON/OFF   and recycling and thus prevent potential
button (back panel).                negative effects on the environment and
human health.
2

Instruction manual
Important safeguards                AС operation
•  The appliance is for household use only.
•  Before the first connecting of the appliance
•  The instruction manual contains important   check that voltage indicated on the rating label
operating and maintenance instructions. For   corresponds the mains voltage in your home.
your safety, it is necessary to refer the manual.   •  Insert the plug into the power supply.
Keep the manual for use in future.    •  The set is now working as electronic clock.
•  Do not hit or drop the unit.
•  Do not expose the unit to vibration,
direct sunlight, too high or low temperature or   General operations
humidity.
•  If you are not going to use the unit within
a long period of time, remove the batteries to   Setting the clock and calendar
avoid their leakage.                  •  Press and hold MODE button. Press it
•  Do not disassemble the unit yourselves.   repeatedly to cycle through time and calendar
Refer servicing to qualified service personnel.  settings in following order: Year => Month =>
Day => 12/24H mode => Current hours =>
Current minutes. The selected setting will blink.
Power supply                        •  Press repeatedly TEMP/   button or
press and hold it to decrease the setting; press
repeatedly Y-M-D/   button or press and hold
Battery operation                 it to increase the setting.
•  Insert 1 x 3 V lithium battery CR2032 (not   •  In normal mode, press repeatedly Y-M-D/
included) to the terminal inside the battery    button to switch the display between
compartment according to the polarity marks (+   current time, year and month and day. Each
and -). Your set will not work normally from the   indication will be on for 5 seconds, then the
battery supply, but there is now the advantage   display returns to initial mode.
that, in case there is a mains current failure,
your clock will continue to work. The clock   Dimmer function
display will not light up, the clock time and   To adjust brightness of display, slide
alarm setting will be held in the clock memory   DIMMER switch to HIGH or LOW position.
by the battery back-up system.
This enables you to move the set from place to   Reset
place without re-setting the clock every time. The   To reset all settings of the unit to default
battery back-up system is only meant to be used   settings, press the RESET hole with a pointed
from short temporary power failures. For longer   object (e.g., a ballpoint pen). This measure is
durations the battery may become exhausted or   needed when you changed the batteries in the
there may be some deviation in accuracy.  unit or if the unit does not function correctly.
•  When the battery is exhausted, it should
be removed from the set to prevent leakage.   Daylight saving time
If you do not wish to take advantage of the   Press and hold Y-M-D/   button to
battery back-up system, your set will work   switch on or off the DST (Daylight Saving
normally without a battery. However, if   Time) mode. This enables to observe 1-hour
disconnected from the mains, the clock figures   difference between summer and winter time.
will flash when the mains are reconnected and
you must re-set the clock.            Thermometer
Press TEMP/   button to show the current
3