Часы с радиоприёмником HYUNDAI H-1541. Инструкция на русском языке

H-1541
RADIO WITH ALARM                        РАДИОПРИЕМНИК
С БУДИЛЬНИКОМ
Instruction manual          Руководство по эксплуатации

Instruction manual                                                                                                        Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
1.  BAND button
2.  TEMP/   button
3.  Y-M-D/   button
4.  AL.1 button
5.  DIMMER switch
6.  SNOOZE/SLEEP button
7.  LIGHT switch
8.  AL.2 button                   1  2  3 4  5  6  7  8  9 10 11
9.  AL.SET button
10. MODE button
11.   button
Not indicated: power cord (back panel), FM antenna (back panel), temperature sensor (back
panel), line input (back panel), battery compartment (bottom), TUNER regulator (right panel),
VOLUME regulator (right panel), RESET button hole (left panel), display (front panel).
Important safeguards                Power supply
•  The instruction manual contains important   Battery operation
operating and maintenance instructions. For   •  Insert 1 x 3 V lithium battery CR2032 (not
your safety, it is necessary to refer the manual.   included) to the terminal inside the battery
Keep the manual for use in future.  compartment according to the polarity marks (+
•  Do not hit or drop the unit.   and -). Your set will not work normally from the
•  Do not expose the unit to vibration,   battery supply, but there is now the advantage
direct sunlight, too high or low temperature or   that, in case there is a mains current failure,
humidity.                           your clock will continue to work. The clock
•  If you are not going to use the unit within   display will not light up, the clock time and
a long period of time, remove the batteries to   alarm setting will be held in the clock memory
avoid their leakage.                by the battery back-up system.
•  Do not disassemble the unit yourselves.   This enables you to move the set from place to
Refer servicing to qualified service personnel.  place without re-setting the clock every time. The
battery back-up system is only meant to be used
from short temporary power failures. For longer
2                                                                                                                                                  3

Instruction manual                                Instruction manual
durations the battery may become exhausted or   Reset
there may be some deviation in accuracy.  To reset all settings of the unit to default
•  When the battery is exhausted, it should   settings, press the RESET hole with a pointed
be removed from the set to prevent leakage.   object (e.g., a ballpoint pen). This measure is
If you do not wish to take advantage of the   needed when you changed the batteries in the
battery back-up system, your set will work   unit or if the unit does not function correctly.
normally without a battery. However, if
disconnected from the mains, the clock figures   Daylight saving time
will flash when the mains are re-connected and   Press and hold Y-M-D/   button to
you must re-set the clock.          switch on or off the DST (Daylight Saving
Time) mode. This enables to observe 1-hour
AС operation                      difference between summer and winter time.
•  The appliance is for household use only.
•  Before the first connecting of the appliance   Thermometer
check that voltage indicated on the rating label   Press TEMP/   button to show the current
corresponds the mains voltage in your home.  temperature. The temerature indicatoin will
•  Insert the plug into the power supply.  be on for 5 seconds, the the display returns to
•  The set is now working as electronic clock.  initial mode. Press and hold TEMP/   button
to switch between Celsius and Fahrenheit
temperature modes.
General operations
Line input
Setting the clock and calendar      •  You can connect the audio output of an
•  Press and hold MODE button. Press it   external device to this unit, to listen to the
repeatedly to cycle through time and calendar   sound of that device through the amplifier of
settings in following order: Year => Month =>   this unit.
Day => 12/24H mode => Current hours =>   •  To connect an external audio device (eg.
Current minutes. The selected setting will blink.  MP3 player), please use a standard stereo
•  Press repeatedly TEMP/   button or   cable (not included) with 3.5 mm to 3.5 mm
press and hold it to decrease the setting; press   plugs to connect the headphone out or audio
repeatedly Y-M-D/   button or press and hold   line-out of the external device to the Line input
it to increase the setting.         socket of this unit.
•  In normal mode, press repeatedly Y-M-D/
button to switch the display between
current time, year and month and day. Each   Radio operation
indication will be on for 5 seconds, the the
display returns to initial mode.      Tuner operations
•  Press   button to turn the radio on or off.
Dimmer function                     •  Press BAND button to switch between AM
To adjust the brightness of the display, slide   and FM radio bands.
DIMMER switch to HIGH or LOW position.  •  Adjust the program by rotating TUNER
regulator.
Bottom backlight                    •  Use VOLUME regulator to adjust volume
To switch on/off backlight of the unit bottom,   level.
slide LIGHT switch to ON or OFF position.  •  To obtain better FM signal reception,
2                                                                          3