Часы с радиоприёмником HYUNDAI H-1505. Инструкция на русском языке

H-1505
ALARM CLOCK RADIO                                                       ????????????? ? ??????
Instruction manual                                                                                     ??????????? ?? ????????????

Description
1.    Time/Lock/Alarm switch
2.    Dimmer switch
3.    Sleep button
4.    Hour button
5.    Minute button
6.    Snooze button
7.    Alarm Off button
8.    Volume control regulator
9.    On/Off/Auto/Alarm switch
10.   Band switch
11.   Tuning control regulator/ Dial lens
Important safeguards
·   CAUTION: To reduce the risk of electric shock, do not remove cover (or back). Prefer servicing to qualified service personnel.
·   DANGEROUS VOLTAGE:            Uninsulated dangerous voltage, that may be of sufficient magnitude to constitute a risk of electrical shock to persons, is
present within this product enclosure.
·   ATTENTION: The owner¶s manual contains important operating and maintenance instructions for your safety, it is necessary to refer the manual.
Power supply
Battery operation
·   Connect a 9 volt (006P) battery (not included) to the terminals inside the battery compartment. There is now the advantage that, in case there is a mains
current failure, your clock will continue to work. The clock display will not light up, but the clock time will be held in the clock memory by the battery
back-up system. This enables you to move the set from place to place without re-setting the clock every time. The battery back-up system is only meant
to be used from short temporary power failures. For longer durations the battery may become exhausted or there may be some deviation in accuracy.
·   When the battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to take advantage of the battery back-up system,
your set will work normally without a battery. However, if disconnected from the mains, the clock figures will flash when the mains are re-connected and
you must re-set the clock as described in the Setting the correct time paragraph.
2

AC operation
·   The appliance is for household use only.
·   Before the first connecting of the appliance check that voltage indicated on the rating label corresponds the mains voltage in your home.
·   Insert the plug into the power supply.
·   The set is now working as an electronic clock and it will flash the clock figures to show you it is not set correctly.
Setting the correct time
·   Slide the Time/Lock/Alarm switch to "TIME" position.
·   Press the Hour button to set correct hours.
·   Press the Minute button to set correct minutes.
·   Slide the Time/Lock/Alarm switch to ?LOCK? position to prevent change the clock time.
Radio operation
Operation
·   Slide the On/Off/Auto/Alarm switch to ?ON? position.
·   Select your desired broadcasting band with Band switch.
·   Rotate the Tuning control regulator to receive the desired broadcast.
·   Adjust the level of sound with Volume control regulator.
Antenna
·   For FM reception, this set is specially equipped with the FM antenna, which is placed near the power line cord.
Wake to radio
Having selected your station and set the volume at the desired level, proceed as follows:
·   Slide the Time/Lock/Alarm switch to ?ALARM? position and On/Off/Auto/Alarm switch to ?AUTO? position.
·   Press the Hour button and then the Minute button until the time when you would like to wake up is reached. The wake up time is now entered into the
timer memory, thus the light indicator ?AUTO?  will light up. Slide the Time/Lock/Alarm switch to ?LOCK?   position to prevent change the alarm time.
To check the wake up time, slide the Time/Lock/Alarm switch to ?ALARM? position. The preset wake up time will continue to be registered in the timer
memory and the radio will switch on by itself at the same time the next day. To switch the radio off, simply press the Alarm Off button.
3