Сетевой фильтр ISOL-8 Cleanline 2. Инструкция на русском языке

is built to exacting standards with the very
from Isol-8.   has taken elements of design from the multi award winning MiniSub,   , we recommend that you study this manual carefully and make yourself   , replace all packing material in the box and store it
Isolate, I SO-lat, v.t. to render free from external influence.   which is without doubt one of the most highly regarded mains distribution and filtration  finest of components to give you the best performance available. Its designer has long  experience in power control and both professional and domestic audio. It is very much a  To make sure that you derive the maximum potential and enjoyment from your   .
Thank you for purchasing the CleanLine?  units currently available. The CleanLine?  product with a distinctive pedigree.   thoroughly familiar with the CleanLine?  After unpacking the CleanLine?  safely for future use.
The CleanLine?           CleanLine?
ISOL-8 Teknologies Limited  ISOL-8 Teknologies Limited   ISOL-8 Teknologies Limited  ISOL-8 Teknologies Limited  70b Stafford Road  70b Stafford Road  70b Stafford Road   70b Stafford Road  Croydon   Croydon    Croydon   Croydon  Surrey    Surrey   Surrey   Surrey  CR0 4NE   CR0 4NE    4NE   CR0 4NE  CR0  info@isol-8.co.uk info@isol-8.co.uk info@isol-8.co.uk info@isol-8.co.uk
13A British chassis sockets   Schuko  IEC fused socket  444 x 85 x 305mm (W x H x D) Domestic version   10 Amps anti surge   10 Amps anti surge  Whilst the information given in this document is correct at the time of printing, small production changes in the  of our company’s policy of improvement through continued research and development might not  necessarily be indicated in the specification. If clarification of any point is required, please refer to
6     European  3.4Kg   200-260VAC   10 Amps
Specifications   Specifications  Specifications    Specifications   Number of available outlets:   Type of outlets available:   Standard Mains Inlet:   Dimensions:   Weight Kg:   Mains Voltage:   Maximum Current:   External mains (live) fuse:   Internal mains (neutral) fuse:      course   appointed supplier.                                            Tel: 020 8404 4104   Tel: 020 8404 4104  Tel: 020 8404 4104 Tel: 020 8404 4104  Fax: 020 8404 4109  Fax: 020 840

significantly reduces mains noise, and especially noise generated from the power amplifier or other loads plugged
require heavy continuous or transient power. These outlets are served by a compound filter design implemented
line so that it also protects the transient suppression devices between neutral and earth. The live to earth devices
phono stages or turntables. These outlets are heavily filtered by a huge purpose built low frequency choke, which
Outlets 3 to 6 are specifically for source components such as pre amps, tuners, CD player, DACs, DVD players,
The filter module is individually fused for it’s own protection as well as that of the load. This fuse is in the neutral
for
Outlets 1 and 2 are specifically for power amplifiers, video projectors, subwoofers or any other product that may
The six outlets are optimised for different loads and are all protected at various stages against mains borne spikes.
or Qube?  or even the mains cable will vary, therefore we encourage    was bought, as it is likely that an internal protection fuse
Mounted on the PCB is a led indicator to show that the module is on and the fuses intact.
are protected by the external fuse located in the IEC inlet.
with only parallel components to avoid current restriction.
for your own system.   for your own system.    for your own system.   for your own system. The way any product relates to either the CleanLine? you to experiment. For the best results in a high-resolution system always use an Isol-8 MainLine?  Check that the mains inlet fuse is intact. (This is located in a draw in the IEC inlet)  Check that the mains inlet cable is correctly plugged into a wall socket and that the plu
The Filter Module  The Filter Module The Filter Module   The Filter Module   Outlets 1 and 2  Outlets 1 and 2  Outlets 1 and 2  Outlets 3 to 6  Outlets 3 to 6  Outlets 3 to 6  into outlets 1 and 2.    Optimising the CleanLine? Optimising the CleanLine? Optimising the CleanLine? Optimising the CleanLine?  the power amplifier(s).   Fault Finding    Fault Finding   Fault Finding   Fault Finding  Front panel indicator not lit and no outlets work;   •   •   •   has
from the mains wall socket and return it to your   or allow any objects to fall into the chassis. Should either of these    to the mains wall socket and avoid using adaptors if possible. We   , was designed for heavier conditioning of larger    is also housed in an extremely
near heat sources, such as radiators or air ducts. Good air circulation is essential to
is an effective mains power conditioner and distribution unit for up to six pieces of audio, digital
on a soft surface, such as a rug or carpet as this could block the ventilation intakes
is capable of taking the weight.    as close as possible to a dedicated mains wall socket. Use a mains lead of as best   with a mains lead, as most customers will have a particular brand, which they  prefer to use. The maximum total load should not exceed 10 Amps or that of the mains lead’s rating if this is less.  Output sockets 1 and 2 are designed for power amplifiers, projectors or powered subwoofers.  Output sockets 3 to 6 are
Introduction.   Introduction.  Introduction.  Introduction.  The CleanLine?  or video electronics.    Safety.    Safety.   Safety.   Safety.  Do not locate the CleanLine?  prevent heat build up within the unit.   Do not place the CleanLine?  on the underside of the chassis.   Make sure that the support for the CleanLine?  Do not let any liquids spill on the CleanLine? happen, immediately switch off and unplug the CleanLine?  authorised Isol-8 dealer.   Getting