Монитор PHILIPS 170X4FS. Инструкция на английском языке

e-Manual
Philips LCD Monitor Electronic User’s Manual
file:///D|/My%20documents/dfu/B2C/ENGLISH/170X4/INDEX.HTM [3/1/2004 6:01:38 PM]

Safety and Troubleshooting Information
•Safety          Safety and Troubleshooting Information
Precautions
and
Maintenance
• Installation
Locations       Safety precautions and maintenance
• FAQs
• Troubleshooting            WARNING: Use of controls, adjustments or procedures other than those
• Regulatory                 specified in this documentation may result in exposure to shock,
electrical hazards and/or mechanical hazards.
Information
• Other Related
Information     Read and follow these instructions when connecting and using your computer monitor:
l     Unplug the monitor if you are not going to use it for an extensive period of time.
l     Unplug the monitor if you need to clean it with a slightly damp cloth. The screen may be wiped
with a dry cloth when the power is off. However, never use alcohol, solvents or ammonia-based
liquids.
l     Consult a service technician if the monitor does not operate normally when you have followed
the instructions in this manual.
l     The casing cover should be opened only by qualified service personnel.
l     Keep the monitor out of direct sunlight and away from stoves or any other heat source.
l     Remove any object that could fall into the vents or prevent proper cooling of the monitor’s
electronics.
l     Do not block the ventilation holes on the cabinet.
l     Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive moisture.
l     When positioning the monitor, make sure the power plug and outlet are easily accessible.
l     If turning off the monitor by detaching the power cable or DC power cord, wait for 6 seconds
before attaching the power cable or DC power cord for normal operation.
l     To avoid the risk of shock or permanent damage to the set, do not expose the monitor to rain or
excessive moisture.
l     IMPORTANT: Always activate a screen saver program during your application. If a still image in
high contrast remains on the screen for an extended period of time, it may leave an 'after-image'
or 'ghost image' on front of the screen. This is a well-known phenomenon that is caused by the
shortcomings inherent in LCD technology. In most cases, the after-image will disappear
gradually over a period of time after the power has been switched off. Be aware, that the after-
image symptom cannot be repaired and is not covered under warranty.
Consult a service technician if the monitor does not operate normally when the operating instructions
given in this manual have been followed.
RETURN TO TOP OF THE PAGE
Installation Locations
l
file:///D|/My%20documents/dfu/B2C/ENGLISH/170X4/safety/safety.htm (1 of 2) [3/1/2004 6:01:42 PM]

Safety and Troubleshooting Information
Avoid exposure to heat and extreme cold
l     Do not store or use the LCD monitor in locations exposed to heat, direct sunlight or extreme
cold.
l     Avoid moving the LCD monitor between locations with large temperature differences. Choose a
site that falls within the following temperature and humidity ranges.
m     Temperature: 5-35°C 41-95°F
m     Humidity: 20-80% RH
l     Do not subject the LCD monitor to severe vibration or high impact conditions. Do not place the
LCD monitor in the trunk of a car.
l     Take care not to mishandle this product by either knocking or dropping it during operation or
transportation.
l     Do not store or use the LCD monitor in locations where there is a high level of humidity or in
dusty environments. Do not allow water or other liquids to spill on or into the LCD monitor.
RETURN TO TOP OF THE PAGE
file:///D|/My%20documents/dfu/B2C/ENGLISH/170X4/safety/safety.htm (2 of 2) [3/1/2004 6:01:42 PM]