Монитор PHILIPS 150C5BS. Инструкция на английском языке

e-Manual
Philips LCD Monitor Electronic User’s Manual
file:///D|/My%20Documents/dfu/C_model/english/150c5/index.htm2004-11-19 12:18:01 PM

Safety and Troubleshooting Information
• Safety           Safety and Troubleshooting Information
Precautions
and
Maintenance
• Installation     Safety precautions and maintenance
Locations
• FAQs
WARNING: Use of controls, adjustments or procedures other than
• Troubleshooting             those specified in this documentation may result in exposure to shock,
• Regulatory                  electrical hazards and/or mechanical hazards.
Information
• Other Related    Read and follow these instructions when connecting and using your computer monitor:
Information
l     Unplug the monitor if you are not going to use it for an extensive period of time.
l     Unplug the monitor if you need to clean it with a slightly damp cloth. The screen may be
wiped with a dry cloth when the power is off. However, never use alcohol, solvents or
ammonia-based liquids.
l     Consult a service technician if the monitor does not operate normally when you have
followed the instructions in this manual.
l     The casing cover should be opened only by qualified service personnel.
l     Keep the monitor out of direct sunlight and away from stoves or any other heat source.
l     Remove any object that could fall into the vents or prevent proper cooling of the monitor’s
electronics.
l     Do not block the ventilation holes on the cabinet.
l     Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive
moisture.
l     When positioning the monitor, make sure the power plug and outlet are easily accessible.
l     If turning off the monitor by detaching the power cable or DC power cord, wait for 6
seconds before attaching the power cable or DC power cord for normal operation.
l     To avoid the risk of shock or permanent damage to the set, do not expose the monitor to
rain or excessive moisture.
l     IMPORTANT: Always activate a screen saver program during your application. If a still
image in high contrast remains on the screen for an extended period of time, it may leave
an 'after-image' or 'ghost image' on front of the screen. This is a well-known phenomenon
that is caused by the shortcomings inherent in LCD technology. In most cases, the after-
image will disappear gradually over a period of time after the power has been switched
off. Be aware, that the after-image symptom cannot be repaired and is not covered under
warranty.
Consult a service technician if the monitor does not operate normally when the operating
instructions given in this manual have been followed.
RETURN TO TOP OF THE PAGE
Installation Locations
file:///D|/My%20Documents/dfu/C_model/english/150c5/safety/safety.htm (1 of 2)2004-11-19 12:18:04 PM

Safety and Troubleshooting Information
l     Avoid exposure to heat and extreme cold.
l     Do not store or use the LCD monitor in locations exposed to heat, direct sunlight or
extreme cold.
l     Avoid moving the LCD monitor between locations with large temperature differences.
Choose a site that falls within the following temperature and humidity ranges.
m     Temperature: 5-35°C 41-95°F
m     Humidity: 20-80% RH
l     Do not subject the LCD monitor to severe vibration or high impact conditions. Do not
place the LCD monitor in the trunk of a car.
l     Take care not to mishandle this product by either knocking or dropping it during operation
or transportation.
l     Do not store or use the LCD monitor in locations where there is a high level of humidity
or in dusty environments. Do not allow water or other liquids to spill on or into the LCD
monitor.
RETURN TO TOP OF THE PAGE
file:///D|/My%20Documents/dfu/C_model/english/150c5/safety/safety.htm (2 of 2)2004-11-19 12:18:04 PM