Роутер TP-LINK TL-WR842ND V1. Инструкция на русском языке

CONTENT
English ·········································································· 1
Az?rbaycan dili······························································ 4
??????? ········································································ 7
?аза?ша ······································································ 11
Русский язык ······························································ 15
Українська мова························································· 19
???????···································································· 23

English
Installation
Note: The product model shown in this QIG isTL-WR740N, as an example.
Insert the provided Resource CD into your CD-ROM drive. Then the
Setup Wizard will automatically pop up on your computer’s screen.
The Easy Setup Assistant
will automatically pop up on
your computer’s screen.
Please select your product
model and click Easy
Setup Assistant
Click START, and then
follow the step-by-step
instructions until you
complete the configuration
Troubleshooting
1.     How can I configure my Router without the Resource CD?
1)   Connect your computer to the Router with an Ethernet cable.
2)   Set the IP address of your wired network adapter as ‘Automatically’.
3)   Open your web browser and type in the default login address referring to
the label on the back of product. You can also try typing http://192.168.1.1
or http://192.168.0.1 to access the Router directly.
4)   The default username and password are both admin.
5)   If you have changed the username or password and can not remember it,
you will need to restore your Router’s configuration to its factory default
settings then use the default username and password.
1

English
2.     How do I restore my  Router’s configuration  to its factory default
settings?
With the Router powered
on, press and hold the
RESET button on the rear
panel for 8 to 10 seconds
before releasing it.
Press it for 8 to 10 seconds
Note  Once the Router is reset, the current configuration settings will be lost
and you will need to re-configure the Router.
3.     What can I do if I can not access the Internet?
1)   Check to see if all the connectors are connected  well, including the
telephone line (for your modem), Ethernet cables and power adapter.
2)   Make sure that  you are connected to the TP-LINK Router  with the
computer that was originally connected to your modem, then log on to the
web-based management page and browse to “Network > MAC Clone”,
click “Clone MAC Address” and then click “Save”. Reboot the Router
and try to access the Internet from your computer, if the problem persists,
please go to the next step.
3)   Log on to the web-based management page and browse to “Network >
LAN”, change the default LAN IP address from 192.168.1.1 to 192.168.x.1
(x can be any number from 2 to 254)  to avoid an IP conflict with  your
Modem, click the “Save” button; the Router will then reboot and you may
try to access the Internet from your computer. Please note that the Router
can only be accessed using the new LAN IP address (192.168.x.1).
2