Ростер TP-LINK M7300. Инструкция на английском языке

M7300
LTE-Advanced Mobile Wi-Fi
REV 1.0.0
1910011532

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice.               is a registered trademark
of  TP-LINK  TECHNOLOGIES  CO.,  LTD.  Other  brands  and  product  names  are  trademarks  or
registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to make any
derivative  such  as  translation,  transformation,  or  adaptation  without  permission  from  TP-LINK
TECHNOLOGIES CO., LTD. Copyright © 2015 TP-LINK TECHNOLOGIES CO., LTD. All rights
reserved.
http://www.tp-link.com

FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference  will  not  occur  in  a  particular  installation.  If  this  equipment  does  cause  harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
?    Reorient or relocate the receiving antenna.
?    Increase the separation between the equipment and receiver.
?    Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
?    Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1)  This device may not cause harmful interference.
2)  This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note:  The  manufacturer  is  not  responsible  for  any  radio  or  TV  interference  caused  by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
FCC RF Radiation Exposure Statement:
This  equipment  complies  with  FCC  radiation  exposure  limits  set  forth  for  an  uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna  or  transmitter.  This  equipment  has  been  SAR-evaluated  for  use  in  hand.  SAR
measurements are based on a 5mm spacing from the body and that compliance is achieved at
that distance.