Телефонный адаптер с 1 FXS-портом и 1 WAN-портом 10/100Base-TX D-LINK DVG-2101S. Инструкция на английском языке

This product can be set up                DVG-2101S
using any current web browser,
i.e., Internet Explorer 6 or               VoIP Telephone Adapter
Netscape Navigator 6.2.3.
Before You Begin
1.  If you purchased this VoIP Telephone Adapter to share your high-speed
Internet connection with other computers, you must have an established
Internet account from an Internet Service Provider (ISP).
2.  It’s best to use the same computer that is connected to your router for
configuring the DVG-2101S VoIP Telephone Adapter. The DVG-2101S acts
as a DHCP Client and will be assigned all the necessary IP address
information from your network. See the Quick Installation Guide or the Manual
on the CD-ROM for setting each network adapter to automatically obtain an
IP address.
Check Your Package Contents
D-Link DVG-2101S VoIP Telephone Adapter
CD-ROM (containing Manual and Q.I.G.)
Ethernet Cable
Phone Cable
12V, 1.5A Power Adapter
Using a power supply
Quick Installation Guide   with a different voltage rating
will damage and void the
warranty for this product.
If any of the above items are missing, please contact your reseller.
©2007 D-Link Corporation, Inc. All rights reserved. Trademarks or registered trademarks are the property of their
respective holders. Software and specifications subject to change without notice.
1

Hardware Overview
Front Panel
Register LED                            Phone LED
This LED will light solid
This LED will light solid if the phone   when the telephone is
account registers successfully. This LED   off-hook. A fast blinking
will flash during registering and light off if   LED indicates an
registering fails.                      incoming call and a slow
blinking LED indicates a
message is waiting. This
LED will light off if the
Power LED                               phone connected to the
This LED will light solid when the      phone port is on-hook.
device finishes a self-test and booting
up. This LED will flash during device
self-test and booting and light off if
Provision LED                   WAN LED
This LED will light solid if the   This LED will light solid when a
device provisions successfully.   connection is established and
This LED will flash during      blink to indicate activity. If this
LED does not light up when a
provisioning and light off if   cable is connected, verify the
provisioning fails.             cable connections and make
sure your devices are powered
on.
2

Rear Panel
Reset Button
Use a paper clip to:
1.  Press 1-2 seconds to enable IVR.   Power Receptor
2.  Press 4-6 seconds to reset this unit.   Connects to the provided
3.  Press 8-10 seconds to restore this
unit’s factory default settings.    power adapter.
Phone Port              WAN Port
Connects to your        Connects to your
phone using a           broadband modem
standard phone cable    using an Ethernet
(RJ-11).                cable.
3