Медиаконвертер D-LINK DMC-700SC. Инструкция на русском языке

Quick Install Guide
1000Base-T to 1000Base-SX/LX
Media Converter
1     Connecting to Power
?    This Converter is a plug-and-play device.
?    Connect the supplied AC to DC power adaptor with a
power voltage of 7.5Vdc/1.5Amp to the DC-Jack on the
converter, and then attach the plug into a standard AC outlet.
2  Installing in a Chassis
The Converter can be fit into any of the expansion slots on a special
designed chassis.
Unscrew and pull out the media converter board
y First, install the converter onto a carrier supplied with the chassis:
Step 1- Unscrew and pull out the media converter board.
Step 2- Plug in the media board to any of the vacant slot.
Step 3- Fit the converter onto the carrier and use the screw to secure it.
1

3     LED Indicator
LEDs       State      Indication
Power     Steady      Power on
(PWR)    Lights off   Power off
Lights on     Linking
LINK/ACT
Lights off   Not Linking
4
Link Pass Through Function
LLCF (Link Loss Carry Forward)
When a device connected to the converter and the TP line loss the link,
the converter’s fiber will disconnect the link of transmit, so that the
other ends will know that there is a linkage error on this end. And when
the Fiber line loss the link, the converter’s TP will disconnected, and the
other end will know that there is linkage problem exist.
There is a default LLCF setting on this converter.
LLR (Link Loss Return)
When a device connected to the converter and the fiber line loss the link,
the converter’s fiber will disconnect the link of transmit.
There is a switch to enable or disable the function of the media
converter.
2

Switch 1 : On  -> Forced Mode
Off -> Auto Negotiation mode
Switch 2 : On  -> LLR enable
12                     Off -> LLR disable
12
Switch
There is a two pin DIP switch on the module which define as switch 1
and switch 2:
?    Switch 1: Fiber mode switch
When the switch was turned to “On”, it means that the fiber was turned
to forced mode, and “Off” for auto-negotiation mode.
Note: Be sure the opposite end is using the same setting(forced or Auto-
negotiation). And when using two converters at the same time, the two
converters MUST set to forced mode.
?    Switch 2: LLR
When the switch was turned to “On”, it means that the LLR was
enabled and “Off” for disabled.
Note: When using two converters at the same time, then only one
converter need to enable the LLR function.
The Switch can be mounted in an EIA standard size, 19-inch rack,
which can be placed in a wiring closet with other equipment. To install,
attach the mounting brackets on the switch’s front panel (one on each
side) and secure them with the screws provided.
3