Портативная радиостанция KENWOOD TK-2406. Инструкция на английском языке

INSTRUCTION MANUAL
VHF FM TRANSCEIVER
TK-2406
UHF FM TRANSCEIVER
TK-3406
© B62-2481-00 (M)
09 08 07 06 05 04 03 02 01 00

THANK YOU
We are grateful you have chosen KENWOOD for your land
mobile radio applications.
NOTICES TO THE USER
?  Government law prohibits the operation of unlicensed radio
transmitters within the territories under government control.
?  Illegal operation is punishable by fine and/or imprisonment.
?  Refer service to qualified technicians only.
Safety:  It is important that the operator is aware of, and
understands, hazards common to the operation of any
transceiver.
Firmware Copyrights
The title to and ownership of copyrights for firmware embedded in KENWOOD
product memories are reserved for JVC KENWOOD Corporation.
PRECAUTIONS
•  Do not charge the transceiver and battery pack when they are wet.
•  Ensure that there are no metallic items located between the
transceiver and the battery pack.
•  Do not use options not specified by KENWOOD.
•  If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts.
•  If a headset or headphone is connected to the transceiver, reduce
the transceiver volume.  Pay attention to the volume level when
turning the squelch off.
•  Do not place the microphone cable around your neck while near
machinery that may catch the cable.
•  Do not place the transceiver on unstable surfaces.
•  Ensure that the end of the antenna does not touch your eyes.
•  When the transceiver is used for transmission for many hours, the
radiator and chassis will become hot.  Do not touch these locations
when replacing the battery pack.
•  Do not immerse the transceiver in water.
•  Always switch the transceiver power off before installing optional
accessories.
•  The charger is the device that disconnects the unit from the AC
mains line. The AC plug should be readily accessible.

Turn the transceiver power off in the following locations:
•   In explosive atmospheres (inflammable gas, dust particles, metallic
powders, grain powders, etc.).
•   While taking on fuel or while parked at gasoline service stations.
•   Near explosives or blasting sites.
•   In aircrafts. (Any use of the transceiver must follow the instructions
and regulations provided by the airline crew.)
•   Where restrictions or warnings are posted regarding the use of
radio devices, including but not limited to medical facilities.
•   Near persons using pacemakers.
•   Do not disassemble or modify the transceiver for any reason.
•   Do not place the transceiver on or near airbag equipment while the
vehicle is running.  When the airbag inflates, the transceiver may
be ejected and strike the driver or passengers.
•   Do not transmit while touching the antenna terminal or if
any metallic parts are exposed from the antenna covering.
Transmitting at such a time may result in a high-frequency burn.
•   If an abnormal odor or smoke is detected coming from the
transceiver, switch the transceiver power off immediately,
remove the battery pack from the transceiver, and contact your
KENWOOD dealer.
•   Use of the transceiver while you are driving may be against traffic
laws.  Please check and observe the vehicle regulations in your
area.
•   Do not expose the transceiver to extremely hot or cold conditions.
•   Do not carry the battery pack (or battery case) with metal objects,
as they may short the battery terminals.
•   When operating the transceiver in areas where the air is dry, it is
easy to build up an electric charge (static electricity).  When using
an earphone accessory in such conditions, it is possible for the
transceiver to send an electric shock through the earphone and to
your ear.  We recommend you use only a speaker/microphone in
these conditions, to avoid electric shocks.
i