На сайте 124220 инструкций общим размером 502.87 Гб , которые состоят из 6279380 страниц
Руководство пользователя VITEK VT-2509. Основные функции, характеристики и условия эксплуатации изложены на 20 страницах документа в pdf формате.
Доступно к просмотру 20 страниц. Рекомендуем вам скачать файл инструкции, поскольку онлайн просмотр документа может сильно отличаться от оригинала.
VT-2509 Y Hot air brush Фен-щетка 3 6 10 13 16 1 VT-2509.indd 1 19.09.2014 12:57:51
VT-2509.indd 2 19.09.2014 12:57:52
ENGLISH HOT AIR STYLER VT-2509 Y – run over sharp edges of furniture, The hot air styler is intended for styling dry or – be used as a handle for carrying the unit. slightly wet hair. • Do not touch the unit, the power cord or the power plug with wet hands. Description • Check integrity of the power cord periodically. 1. Attachment installation place • Never use the unit if the power cord or plug is 2. Operation indicator damaged, if the unit works improperly or after 3. Operation mode switch «0/1/2/C» it was dropped. Contact an authorized service 4. Body center for all repair issues. 5. Air inlet grid • Do not use the unit while taking a bath. 6. Hanging loop • Do not put or keep the unit in places where it 7. Attachment lock buttons can fall into a bath or a sink filled with water; 8. Nozzle do not immerse the unit body, the power cord 9. Attachment comb and the power plug into water or any other 10. Brush with pullout bristles O 30 mm liquids. 11. Lever • If the unit is dropped into water, unplug it 12. Brush attachment O 40 mm immediately and only then take it out of the water. ATTENTION! • Never leave the operating unit unattended. • Do not use the unit near containers filled with • Do not use the unit when you are drowsy. water (such as swimming pool etc.). • Do not use the unit to style wet hair or syn- • After using the unit in a bathroom, unplug it by thetic wigs. taking the power plug out of the mains socket, • Install or change the brush attachments only as closeness of water is dangerous even if the when the unit is switched off and unplugged. unit is switched off. • Avoid contact of hot surfaces of the unit with • For additional protection you can install a your face, neck or other parts of your body. residual current device (RCD) with nominal • Do not put the operating unit on heat-sensi- operation current not exceeding 30 mA into tive or soft surfaces (for instance, bed or sofa) the bathroom mains; contact a specialist for and do not cover it. installation. • Take the switched on unit by its handle only. Do not touch the attachments while using SAFETY MEASURES the unit. Before using the unit, read this instruction care- • Be careful! The attachments remain hot for fully and keep it for further reference. some time after the unit is unplugged. Use the unit according to its intended purpose • Before you take the unit away, let it cool down, only, as it is stated in this user manual. Mishandling do not wind the power cord around the unit. the unit can lead to its breakage and cause harm • When unplugging the unit, pull the power plug to the user or damage to his/her property. but not the cord. To avoid the risk of electric shock, observe • Always unplug the unit after every usage and the following safety measures. before cleaning. • Before switching the unit on, make sure that • Clean the unit regularly. your home mains voltage corresponds to the • Do not allow children to touch the unit body unit operating voltage. and the power cord during the unit operation. • Do not switch the unit on in places where • This unit is not intended for usage by children aerosols are sprayed or highly inflammable under 8 years of age. liquids are used. • This unit is not intended for usage by people • Hair spray should be applied only after hair (including children over 8) with physical, neu- styling is finished. ral and mental disorders or with insufficient • It is recommended to unwind the power cord experience or knowledge. Such persons may to its full length while using the unit. use this unit only if they are under supervision • The power cord should not: of a person who is responsible for their safety – touch hot objects, and if they are given all the necessary and – be immersed into water, understandable instructions concerning the 3 VT-2509.indd 3 19.09.2014 12:57:52