Маникюрный набор VICONTE vc-1922. Инструкция на русском языке

MANICURE AND PEDICURE SET
Instruction manual
?Kk?? O?? ?K?j???K j ?oOj???K
??????????? ?? ????????????
VC-1922

DESCRIPTION
1. Big filing disk
2. Large conical file
3. Cylindrical file
4. Small filing disk
5. Cuticle shaper
6. Motor
7. Big filing disk
8. Hoof cone
9. Small conical file
10.Small filing disk
11.Polishing disk
12. Small round brush
13. Nail dryer On/Off button
14. Built-in nail dryer with light
15. Storage case
16. Adapter output
17. Cover opening button
18. Adapter connection socket
IMPORTANT SAFETY INSTRUCTIONS
·   Please read this instruction manual carefully before use and keep in a safe place for future reference.
·   Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains
voltage in your home.
·   Do not use the appliance for any other purposes than those described in this instruction manual.
·   Home use only. Do not use for industrial purposes.
·   Do not reach the appliance if it falls into water. Unplug immediately.
·   Always unplug the appliance from the power supply when not in use and before cleaning.
·   To protect against the risk of electric shock, do not immerse the appliance in water or in any other liquids.
·   Close supervision is necessary when it is used near children.
·   Do not use other attachments than which supplied.
2

·   Never carry or suspend the appliance by the cord.
·   Do not operate after malfunction or damage of cord.
·   Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the nearest
service center.
BEFORE USING FOR THE FIRST TIME
REGHARGE THE UNIT
·   The unit must be charged for at least 24 hours before the first use to ensure that the batteries are fully charged. The
normal recharging time is 6 hours for full recharge.
·   Turn the on/off switch to "0"  (off position) and put the unit into the storage box.
·   Connect the micro motor to adapter output located on the case.
·   The network adapter is at the bottom of the case. Connect it to the socket on a back side of the case and connect it to a
network. The light indicator will light up.
·   Plug the adaptor to the electrical socket.
INSTRUCTION FOR USE
·   To connect the attachments to the main body, directly push them in.
·   To remove them, just pull them off the head of the unit.
·   Make sure that the on/off switch is in the off position before connecting or removing attachments.
On/Off switch
Indicator light
Head of the unit
3