Машинка для стрижки VICONTE vc-1462. Инструкция на русском языке

HAIR CLIPPER SET
Instruction manual
НАБОР ДЛЯ СТРИЖКИ ВОЛОС
Руководство по эксплуатации
VC-1462

6
7
4                        5      3 mm   8  6 mm
2
3
1                               9 mm      12 mm         9      10   11    12
13
1. Blade guard           8. 4 detachable combs
2. Blades                9. Barber comb
3. Blade adjustment level  10. Scissors
4. Housing               11. Oil
5. On/Off switch         12. Brush
6. Cord swivel protection  13. Thinning plate lock button
7. Hanging loop
IMPORTANT SAFEGUARDS
When using electrical appliance, especially when children are present, basic safety precautions should always be followed,
including the following:
• Home use only. Do not use for industrial purpose.
• To reduce the risk of death or injury by electric shock unplug this appliance before cleaning.
• Do not place or store appliance where it can fall or be pulled into a tub or sink.
• Do not use while bathing or in a shower.
• Do not immerse the appliance in water or other liquids.
• Do not use an appliance that has fallen into water. Unplug it immediately.
• Use this appliance only for its intended use as described in this manual.
• Do not use attachments not recommended by the manufacturer.

• This appliance should never be left unattended when plugged in.
• Close supervision is necessary when this appliance is used on, or near children or invalids.
• Never operate this appliance if it has a damaged cord or plug, if it is not working properly.
• Keep the cord away from heated surfaces.
• Do not pull, twist, or wrap the power cord around appliance.
• Never drop or insert any object into any opening of this appliance.
• Before use, make certain of blades are aligned properly.
• Do not place appliance on any surface while it is operating.
•  Do not use this appliance neither with a damaged or broken comb nor with teeth missing from the blades as injury
may occur.
NOTE: KEEP BLADES OILED.
BLADE ALIGNMENT
• Your clippers were carefully examined to ensure that the blades were oiled and aligned before
leaving our factory.
• Blades must be realigned if they have been removed for cleaning or replacement.
• To realign the blades, simply match the upper and bottom blades teeth up, point for point.
• End of top blade teeth should be approximately 1.2 mm back from bottom blade. Compare your clipper
blades with the sketch.
• If blade alignment is incorrect, add a few drops of oil to the blades, switch on clipper for a few moments,
switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is aligned.
OIL
• To maintain your clipper in peak condition, the blades should be oiled every few haircuts.
• Do not use hair oil, grease, oil mixed with kerosene or any solvent. As the solvent will evaporate and leave
the thick oil which may slow down the blades motion.