Набор для укладки MAXWELL MW-2011 SR. Инструкция на русском языке

Набор для укладки/Styling set
MW
2011
29.06.2011   16:37:10
MW_2011_INSTRUKZ-2 vida.indd   1
MW_2011_INSTRUKZ-2 vida.indd   1                                      29.06.2011   16:37:10

2
1
3
4
5
6
29.06.2011   16:37:12
MW_2011_INSTRUKZ-2 vida.indd   2
MW_2011_INSTRUKZ-2 vida.indd   2                                      29.06.2011   16:37:12

ENGLISH
Description                          •   Keep the unit away from hot surfaces.
1. Concentrator attachment           •   Never block the air openings of the appliance or
2.  Removable air inlet grid            place it on a soft surface, such as a bed or couch,
3.  “Cool shot” button                  where the air openings may be blocked. Keep the
4.  Heating degree switch (1-2-3)       air openings free of lint, dust and hair etc
5.  Air supply speed switch (0-1-2)  •   Do not use the unit when you are drowsy.
6. Hanging loop                      •   Never drop or insert any object into any openings
of the unit.
ATTENTION! Do not use the unit near objects filled   Do not use the hair-dryer near aerosols or inflam-
•
with water (bath, swimming pool etc.).  mable liquids.
When using the hair dryer in a bathroom, discon-
•                                       Do not direct hot air into your eyes or other parts
•
nect it after usage, pull the plug out of the socket,   of your body, which are sensitive to heat.
as when water is near it is dangerous even if the   The attachment gets hot during use. Allow it to
•
unit switch is in «off» position;     cool before removal.
For additional protection you can install a residual
•                                       Avoid getting of hair into the air inlet grid during
•
current device with nominal current of operation,   operation of the unit.
not exceeding 30 mA into the mains of the bath-
room; while installation, refer to a specialist;  THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
Safety measures                      Keep these instructions
When using electrical appliances, especially near
children, it is necessary to follow the main safety   Switching on of the hair-dryer
measures, including the following:   Before using, make sure that your home electricity
supply corresponds to the voltage specified on the
BEFORE USING THE UNIT READ ALL THE   housing of the unit.
INSTRUCTIONS CAREFULLY               –   Insert the plug into the socket.
–   Use the air supply speed switch (5) to set the
To protect against risk of a fire or electric shock:  required speed:
Before using, make sure that your home electric-        0 = off.
•
ity supply corresponds to the voltage specified         1 = low speed;
on the housing of the unit.                2 =high speed;
Always unplug the unit after usage.  –  Use the heating degree switch (4) to set the
•
Do not place or store the appliance in places where   required temperature of air flow.
•
it can fall into a tub or sink, filled with water.        1 = low heating
Do not operate the unit while bathing.         = medium heating
•
Never immerse the unit into water or other liq-        3 = maximal heating
•
uids.
If the hair–dryer falls into water, unplug it imme-  Hair Care
•
diately. And only then you can take it out of the   To get the best results (before drying or styling) wash
water.                             your hair with shampoo, dry it with a towel to remove
Never leave the operating unit unattended.  excess of moisture and comb your hair.
•
This unit is not intended for usage by children
•
or disabled persons unless they are given all the   Quick drying
necessary instructions on safety measures and   Set the switch (4) to the maximal heating position
information about danger, which can be caused   “3”, select the required air supply speed using the
by improper usage of the unit.     switch (5). Remove excess of moisture with your
Use the unit only for its purposes, use only the at-  hand or a comb from hair and constantly move the
•
tachments supplied with the unit.  hair–dryer above your hair.
Never use the unit if the power cord or plug is
•
damaged; if the unit malfunctions or after it fell   Straightening
into water. Apply to the authorized service centre   Set the switch (4) to the maximal heating position
for repair.                        “3”, select the required air supply speed using the
3
29.06.2011   16:37:12
MW_2011_INSTRUKZ-2 vida.indd   3                                      29.06.2011   16:37:12
MW_2011_INSTRUKZ-2 vida.indd   3