Тюнер ROTEL RT-11 V2. Инструкция на русском языке

RT-11
DAB/FM Stereo Tuner
Tuner Stereo DAB/FM
DAB/FM-Stereo-Tuner
Sintonizador Estereofonico de FM/DAB
DAB+/FM-stereotuner
Sintonizzatore FM Stereo/DAB
DAB/FM-radio
DAB/FM стерео тюнер
Owner’s Manual
Manuel de l’utilisateur
Bedienungsanleitung
Manual de Instrucciones
Gebruikershandleiding
Manuale di istruzioni
Instruktionsbok
Инструкция пользователя

2                                                                               RT-11 DAB/FM Stereo Tuner
This symbol means that this unit is double insulated. An earth connection
is not required.
DAB
Rotel products are designed to comply with international directives
on the Restriction of Hazardous Substances (RoHS) in electrical
and electronic equipment and the disposal of Waste Electrical and
Electronic Equipment (WEEE). The crossed wheelie bin symbol
indicates compliance and that the  products must be appropriately
recycled or processed in accordance with these directives.

English                                                                                                3
Notice                                                 Important Safety Instructions
The rear RS232 connection should be handled by authorized persons only.
WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel.
FCC Information
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant   not expose the unit to dripping or splashing. Do not place objects filled with liquids, such as vases, on the
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful   unit. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture, or a foreign
interference in a residential installation. This equipment generates, uses and can radiate radio frequency   object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a
energy and, if not installed and used in accordance with the instruction, may cause harmful interference   qualified service person for inspection and necessary repairs.
to radio communications.
Read all the instructions before connecting or operating the component.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the   Keep this manual so you can refer to these safety instructions.
equipment off and on, the user is encouraged to try to correct the interference by one or more of the   Heed all warnings and safety information in these instructions and on the product itself. Follow all
following measures:                                    operating instructions.
• Reorient or relocate the receiving antenna.(TV, radio, etc.)
• Increase the separation between the equipment and receiver.  Clean the enclosure only with a dry cloth or a vacuum cleaner.
• Connect the equipment to an outlet on circuit different from that to which the receiver is connected.  Do not use this unit near water.
• Consult the dealer or an experienced radio/TV technician for additional help.
Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation openings. If
the unit is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper cooling.
Caution                                                Keep the component away from radiators, heat registers, stoves, or any other appliance that produces heat.
This device complies with part 15 of the FCC Rules. Operation is subject to the following to conditions: (1)   WARNING: The rear panel power cord connector is the mains power disconnect device. The device must
This device may not cause harmful interference, and (2) this device must accept any interference received,   be located in an open area that allows access to the cord connector.
including interference that may cause undesired operation.
The unit must be connected to a power supply only of the type and voltage specified on the rear panel.
NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna installer’s attention   (USA: 120 V/60Hz, EC: 230V/50Hz)
to Article 820-40 of the NEC. This provides guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding system of the building, as close to the point of   Connect the component to the power outlet only with the supplied power supply cable or an exact equivalent.
cable entry as practical. See installation diagram.    Do not modify the supplied cable. A polarized plug has two blades, with one wider than the other. A
grounding plug has two blades plus a third grounding prong. These are provided for your safety. Do not
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,   defeat grounding and/or polarization safety provisions. If the supplied plug does not fit your outlet, please
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against   consult an electrician for replacement of the obsolete outlet. Do not use extension cords.
interference in a residential installation. This equipment generates and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause interference to radio or TV   The main plug of the power cord set is a disconnect device of the apparatus. In order to completely disconnect
communications. There is no guarantee that interference will not occur in a particular installation. If this   the apparatus from the supply mains, the main plug of the power cord set should be unplugged from the
equipment does cause interference to radio or television reception, which can be determined by turning   mains (AC) outlet. The stand-by LED indicator will not be lit up to show the power cord is unplugged. The
the equipment off and on, try to correct the interference by one or more of the following measures:  disconnect device shall remain readily operable.
• Reorient or relocate the receiving antenna.          Do not route the power cord where it will be crushed, pinched, bent, exposed to heat, or damaged in any
• Increase the separation between the unit and the television tuner.  way. Pay particular attention to the power cord at the plug and where the cord exits the back of the unit.
• Connect the unit to an AC power outlet on a different electrical circuit.
• Consult your authorized Rotel retailer for assistance.  The power cord should be unplugged from the wall outlet during a lightning storm or if the unit is to be
left unused for a long period of time.
Use only accessories specified by the manufacturer.
Use only with a cart, stand, rack, bracket or shelf system recommended by Rotel. Use
caution when moving the unit in a stand or rack to avoid injury from a tip-over.
Immediately stop using the component and have it inspected and/or serviced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation.
• The unit has been dropped or damaged in any way.
The batteries in the remote control should not be exposed to excessive temperature such as sunshine,
fire or other heat sources.